4

LT1007/LT1037

LT1007I/LT1037I

SYMBOL

PARAMETER

CONDITIONS

MIN

TYP

MAX

UNITS

Input Offset Voltage

(Note 1)

q

40

125

µV

Average Input Offset Drift

(Note 9)

q

0.3

1.0

µV/°C

∆Temp

Input Offset Current

q

20

80

nA

Input Bias Current

q

±25

±90

nA

Input Voltage Range

q

±10

±11.7

V

CMRR

Common Mode Rejection Ratio

q

105

120

dB

PSRR

Power Supply Rejection Ratio

q

101

120

dB

Large-Signal Voltage Gain

q

2.0

15.0

V/

µV

q

1.5

12.0

V/

µV

Maximum Output Voltage Swing

q

±12.0 ±13.6

V

Power Dissipation

q

95

165

mW

LT1007AM/LT1037AM

LT1007M/LT1037M

SYMBOL

PARAMETER

CONDITIONS

MIN

TYP

MAX

MIN

TYP

MAX

UNITS

Input Offset Voltage

(Note 1)

q

25

60

50

160

µV

Average Input Offset Drift

(Note 9)

q

0.2

0.6

0.3

1.0

µV/°C

∆Temp

Input Offset Current

q

15

50

20

85

nA

Input Bias Current

q

±20

±60

±35

±95

nA

Input Voltage Range

q

±10.3 ±11.5

±10.3 ±11.5

V

CMRR

Common Mode Rejection Ratio

q

112

126

104

120

dB

PSRR

Power Supply Rejection Ratio

q

104

126

100

120

dB

Large-Signal Voltage Gain

q

3.0

14.0

2.0

14.0

V/

µV

q

2.0

10.0

1.5

10.0

V/

µV

Maximum Output Voltage Swing

q

±12.5 ±13.5

±12.0 ±13.5

V

Power Dissipation

q

100

150

100

170

mW

temperature range.

For MIL-STD components, please refer to LTC 883C data sheet for test

listing and parameters.

Note 1: Input Offset Voltage measurements are performed by automatic

test equipment approximately 0.5 seconds after application of power. AM

and AC grades are guaranteed fully warmed up.

Note 2: Long Term Input Offset Voltage Stability refers to the average

trend line of Offset Voltage vs Time over extended periods after the first 30

during the first 30 days are typically 2.5

µV. Refer to typical performance

curve.

Note 3: This parameter is tested on a sample basis only.

Note 4: 10Hz noise voltage density is sample tested on every lot. Devices

100% tested at 10Hz are available on request.

Note 5: See the test circuit and frequency response curve for 0.1Hz to

10Hz tester in the Applications Information section.

Note 6: See the test circuit for current noise measurement in the

Applications Information section.

Note 7: This parameter is guaranteed by design and is not tested.

Note 8: The inputs are protected by back-to-back diodes. Current limiting

resistors are not used in order to achieve low noise. If differential input

voltage exceeds

±0.7V, the input current should be limited to 25mA.

Note 9: The Average Input Offset Drift performance is within the

specifications unnulled or when nulled with a pot having a range of 8k

Ω to

20k

Ω.