LT1208CS8 datasheet(6/12 Pages) LINER

6 / 12 page

LT1208/LT1209

HARA TERISTICS

TYPICALPERFOR

Gain-Bandwidth and Phase Margin

Total Harmonic Distortion

vs Supply Voltage

Slew Rate vs Supply Voltage

vs Frequency

APPLICATI

I FOR ATIO

Layout and Passive Components

As with any high speed operational amplifier, care must be

taken in board layout in order to obtain maximum perfor-

mance. Key layout issues include: use of a ground plane,

minimization of stray capacitance at the input pins, short

lead lengths, RF-quality bypass capacitors located close

to the device (typically 0.01

µF to 0.1µF), and use of low

ESR bypass capacitors for high drive current applications

(typically 1

µF to 10µF tantalum). Sockets should be

avoided when maximum frequency performance is re-

quired, although low profile sockets can provide reason-

able performance up to 50MHz. For more details see

Design Note 50. The parallel combination of the feedback

resistor and gain setting resistor on the inverting input

combine with the input capacitance to form a pole which

can cause peaking. If feedback resistors greater than 5k

are used, a parallel capacitor of value

CF ≥ RG × CIN/RF

should be used to cancel the input pole and optimize

dynamic performance. For unity-gain applications where

a large feedback resistor is used, CF should be greater than

or equal to CIN.

Capacitive Loading

The LT1208/LT1209 amplifiers are stable with capacitive

loads. This is accomplished by sensing the load induced

output pole and adding compensation at the amplifier gain

node. As the capacitive load increases, both the bandwidth

and phase margin decrease so there will be peaking in the

frequency domain and in the transient response. The

photo of the small-signal response with 1000pF load

shows 50% peaking. The large-signal response with a

10,000pF load shows the output slew rate being limited by

the short-circuit current. To reduce peaking with capaci-

tive loads, insert a small decoupling resistor between the

output and the load, and add a capacitor between the

output and inverting input to provide an AC feedback path.

Coaxial cable can be driven directly, but for best pulse

fidelity the cable should be doubly terminated with a

resistor in series with the output.

SUPPLY VOLTAGE (±V)

1208/09 G19

PHASE MARGIN

GAIN BANDWIDTH

TA = 25°C

SUPPLY VOLTAGE (±V)

1208/09 G20

600

500

400

300

200

100

–SR

+SR

TA = 25°C

AV = –1

FREQUENCY (Hz)

0.001

0.01

10k

1208/09 G21

100

100k

AV = –1

AV = 1

TA = 25°C

VOUT = 3VRMS

RL = 500Ω

LT1208CS8 Scheda tecnica(PDF) 6 Page - Linear Technology

LT1208CS8 Scheda tecnica(HTML) 6 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Scheda tecnica Scarica

Link URL