AC-DC Din Rail Power Supply

ADF240C

240 Watts

http://www.archcorp.com.tw

TEL: +886-2-26989508

FAX: +886-2-26981319

-2-

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and +25°C of ambient temperature.

2. Ripple & Noise are measured at 20MHz of bandwidth with 0.1uF & 47uF parallel capacitor.

3. The power supplies can connected in parallel to offer the current share function.

4. Derating may be needed under low input voltage. Please check the derating curve for more details.

5. After 30 minutes of burn-in

6. Parallel Operation with Remote Sensing:

(1). Parallel operation is available by connecting the units shown as below (+S,-S and CS are connected mutually in parallel)

(2). Difference in Vout among parallelled units should be less than +/-1%

(3). The total output current must not exceed the value determined by the following equation (Output current at parallel

operation)=(The rated current per unit) x (Number of unit) x 0.9.

(4). In parallel operation 4 units is the maximum, please consult the manufacture for other applications.

(5). When remote sensing is used in parallel operation, the sensing wire must be connected only to the master unit.

(6). When in parallel operation, the minimum output load should be greater than 3% of total output load.(Min. load > 3% rated

current per unit x number of unit)