IPC01 datasheet(2/9 Pages) MICROPAC

2 / 9 page

BY MICROPAC

Industrial Power Controller

Micropac Industries

cannot assume any responsibility for any circuits shown, or represent that they are free from patent infringement.

Micropac

reserves the right to make changes at any time in order to improve design and to supply the best product possible.

Micropac Industries, Inc.

 905 E. Walnut St., Garland, TX 75040  (972) 272-3571  Fax (972) 494-2281

©March 2013

www.micropac.com

E-MAIL:

microsales@micropac.com 12/18/2013 Rev G

Pg. 2 of 9

ABSOLUTE MAXIMUM RATINGS

1. External snubbing may be required for Power Controller protection.

2. Reversing output polarity on DC units may cause permanent damage.

3. The I

2t circuit breaker function terminates AC overloads and fault currents per Figures 1 or 2 and

DC overloads and fault currents per Figures 3 or 4.

AC ELECTRICAL OUTPUT CHARACTERISTICS:

TC = -40 to 80° C

Description

Units

Device

40VAC / 10A

280VAC / 5A

Rated Operating Voltage

VRMS

0 – 40

0 - 280

Overvoltage (Maximum)

VRMS

310

Transients (Maximum)

VPEAK

424

Operating Frequency

50 – 450

50 - 450

Current Rating

ARMS

Interrupt Current Rating

2,3

APEAK

100

Turn-On / Turn-Off Time

mSec

Turn-On / Turn-Off Delay

mSec

Trip Shutdown Time

3,5

µSec

Maximum Off-State Leakage @ Rated Voltage

µA

500

Maximum On-State Voltage Drop @ Rated Current

VRMS

0.75

Maximum On-State Resistance @ Rated Current

Ohms

0.15

0.30

1. This is not a “zero crossing Turn-On” IPC. Turn-On at other than zero-crossing will experience a “soft-start” voltage

and current equal to the typical Turn-On Rise Time of 8msec. At 60 Hz this is ½ sin of the normal voltage rise and is

2.5 cycles for 400 Hz.

2. Steady state trip current is between 120% and 160% of rated current. See Figures 1 and 2.

3. I

2t trip current is time dependent. See Figures 1 and 2.

4. Output of 10 to 90% / 90 to 10%.

5. Output current measured from fault onset to 10% rated load.

6. “ON” command period is 1 sec minimum with a duty cycle of 10%.

Description

DC IPC

AC IPC

Isolation Voltage

1,500 VDC

1,500VDC

Load Voltage

75 / 400V VDC

1,2

40 / 280VAC RMS

Load Current

Less Than 8 Times Rated Operating

Current / Self Protecting

Self Protecting to MIL-STD-1760E

Bias supply voltage, VDD

-0.6 to 32 VDC

Control Voltage

1 Volt above VDD / 1 Volt below Return 1 Volt above VDD / 1 Volt below Return

Operating Temperature, Case

-40ºC to +80ºC

Storage Temperature

-55ºC to +85ºC

IPC01 Scheda tecnica(PDF) 2 Page - Micropac Industries

IPC01 Scheda tecnica(HTML) 2 Page - Micropac Industries

Html Pages

1 2 3 4 5 6 7 8 9

Scheda tecnica Scarica

Link URL