6

P/N:PM0579

REV. 1.6, NOV. 21, 2002

MX29F080

First Bus

Second Bus

Third Bus

Fourth Bus

Fifth Bus

Sixth Bus

Command

Bus

Cycle

Cycle

Cycle

Cycle

Cycle

Cycle

Cycle

Addr

Data

Addr

Data

Addr

Data

Addr

Data Addr

Data Addr

Data

Reset

1

XXXH

F0H

Read

1

RA

RD

Read Silicon ID

4

555H

AAH

2AAH 55H

555H

90H

ADI

DDI

Sector Group

4

555H

AAH

2AAH 55H

555H

90H

SGAx02 00H

Protect Verify

01H

Program

4

555H

AAH

2AAH 55H

555H

A0H

PA

PD

Chip Erase

6

555H

AAH

2AAH 55H

555H

80H

555H

AAH 2AAH 55H 555H 10H

Sector Erase

6

555H

AAH

2AAH 55H

555H

80H

555H

AAH 2AAH 55H SA

30H

Sector Erase Suspend

1

XXXH

B0H

Sector Erase Resume

1

XXXH

30H

TABLE 1. SOFTWARE COMMAND DEFINITIONS

Note:

1. ADI = Address of Device identifier; A1=0, A0 = 0 for manufacture code,A1=0, A0 = 1 for device code. A2-A19=do

not care. (Refer to Table 3)

DDI = Data of Device identifier : C2H for manufacture code, D5H for device code.

X = X can be VIL or VIH

RA=Address of memory location to be read.

RD=Data to be read at location RA.

2. PA = Address of memory location to be programmed.

PD = Data to be programmed at location PA.

SA = Address of the sector to be erased. Address A16-A19 select a unique sector.

SGA=Address of the sector group. Address A17~A19 select a unique sector group.

3. The system should generate the following address patterns: 555H or 2AAH to Address A10~A0 .

Address bit A11~A19=X=Don't care for all address commands except for Program Address (PA) and Sector

Address (SA). Write Sequence may be initiated with A11~A19 in either state.

4. For Sector Group Protect Verify Operation : If read out data is 01H, it means the sector has been protected. If read

out data is 00H, it means the sector is still not being protected.

COMMAND DEFINITIONS

Device operations are selected by writing specific ad-

dress and data sequences into the command register.

Writing incorrect address and data values or writing them

in the improper sequence will reset the device to the

read mode. Table 1 defines the valid register command

sequences. Note that the Erase Suspend (B0H) and

Erase Resume (30H) commands are valid only while the

Sector Erase operation is in progress. Either of the two

reset command sequences will reset the device(when

applicable).