LP3962, LP3965

www.ti.com

SNVS066H – MAY 2000 – REVISED APRIL 2013

The primary source of noise in low-dropout regulators is the internal reference. In CMOS regulators, noise has a

low frequency component and a high frequency component, which depend strongly on the silicon area and

quiescent current. Noise can be reduced in two ways: by increasing the transistor area or by increasing the

current drawn by the internal reference. Increasing the area will decrease the chance of fitting the die into a

smaller package. Increasing the current drawn by the internal reference increases the total supply current

(ground pin current). Using an optimized trade-off of ground pin current and die size, LP3962/LP3965 achieves

low noise performance and low quiescent current operation.

The total output noise specification for LP3962/LP3965 is presented in the Electrical Characteristics table. The

Output noise density at different frequencies is represented by a curve under typical performance characteristics.

SHORT-CIRCUIT PROTECTION

The LP3962and LP3965 is short circuit protected and in the event of a peak over-current condition, the short-

circuit control loop will rapidly drive the output PMOS pass element off. Once the power pass element shuts

down, the control loop will rapidly cycle the output on and off until the average power dissipation causes the

thermal shutdown circuit to respond to servo the on/off cycling to a lower frequency. Please refer to the section

on thermal information for power dissipation calculations.

ERROR FLAG OPERATION

The LP3962/LP3965 produces a logic low signal at the Error Flag pin when the output drops out of regulation

due to low input voltage, current limiting, or thermal limiting. This flag has a built in hysteresis. The timing

diagram in Figure 22 shows the relationship between the ERROR and the output voltage. In this example, the

input voltage is changed to demonstrate the functionality of the Error Flag.

The internal Error flag comparator has an open drain output stage. Hence, the ERROR pin should be pulled high

through a pull up resistor. Although the ERROR pin can sink current of 1mA, this current is energy drain from the

input supply. Hence, the value of the pull up resistor should be in the range of 10k

Ω to 1MΩ. The ERROR pin

must be connected to ground if this function is not used. It should also be noted that when the shutdown pin

is pulled low, the ERROR pin is forced to be invalid for reasons of saving power in shutdown mode.

Figure 22. Error Flag Operation

Copyright © 2000–2013, Texas Instruments Incorporated

Submit Documentation Feedback

13

Product Folder Links: LP3962 LP3965