ML4832CS datasheet(8/15 Pages) MICRO-LINEAR

8 / 15 page

ML4832

The magnitude of the offset voltage that will appear at

the input is given by VOS = io/gm. For an io of 1mA and a

gm of 0.05 µmhos the input referred offset will be 20mV.

Capacitor C1 as shown in Figure 2 is used to block the

DC current to minimize the adverse effect of offsets.

Slew rate enhancement is incorporated into all of the

operational transconductance amplifiers in the ML4832.

This improves the recovery of the circuit in response to

power up and transient conditions. The response to large

signals will be somewhat non-linear as the

transconductance amplifiers change from their low to

high transconductance mode. This is illustrated in

Figure 4.

BALLAST OUTPUT SECTION

The IC controls output power to the lamps via frequency

modulation with non-overlapping conduction. This

means that both ballast output drivers will be low during

the discharging time tDIS of the oscillator capacitor CT.

OSCILLATOR

The VCO frequency ranges are controlled by the output

of the LFB amplifier. As lamp current decreases, LFB

OUT rises in voltage, causing the CT charging current to

decrease, thereby causing the oscillator frequency to

decrease. Since the ballast output network attenuates

high frequencies, the power to the lamp will be

increased.

The oscillator frequency is determined by the following

equations:

OSC

CHG

DIS

(3)

and

tR C In

CHG

REF

+−

(4)

The oscillator’s minimum frequency is set when ICH = 0

where:

OSC

≅

051

(5)

This assumes that tCHG >> tDIS.

When LFB OUT is high, ICH = 0 and the minimum

frequency occurs. The charging current varies according to

two control inputs to the oscillator:

1. The output of the preheat timer

2. The voltage at LFB OUT

In preheat condition, charging current is fixed at

CHG PREHEAT

SET

()

(6)

–

1.25/3.75

VREF

ICHG

VREF

CONTROL

RT/CT

5.5mA

CLOCK

VTH = 3.75V

VTL = 1.25V

tDIS

tCHG

Figure 5. Oscillator Block Diagram and Timing

FUNCTIONAL DESCRIPTION (Continued)

ML4832CS Scheda tecnica(PDF) 8 Page - Micro Linear Corporation

ML4832CS Scheda tecnica(HTML) 8 Page - Micro Linear Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Scheda tecnica Scarica

Link URL