ME60

60W Single Output External Power

Medical Series

www.slpower.com

ME60 Rev 2.4

31-JAN-16

3

EMI/EMC Compliance

Conducted Emissions:

EN55011/CISPR11 Class B, FCC Part 15.107, Class B: 6db margin typ, at 115 and 230Vac

Radiated Emissions:

EN55011/CISPR11 Class B, FCC Part 15.109, Class B: 3db margin typ, at 115 and 230Vac

Common Mode Noise:

High Frequency (100kHz-20MHz): <40mA pk-pk

Electro-Static Discharge (ESD)

Immunity on Power ports:

EN55024/IEC61000-4-2, Level 4: +/- 8kV contact, +/- 15kV air, Criteria A

IEC60601-1-2, 4

Radiated RF EM Fields Susceptibility

EN55022/EN61000-4-3, 10V/m, 80MHz-2.7GHz, 80% AM at 1kHz

IEC60601-1-2, 4

Electrical Fast Transients (EFT) /Bursts:

EN55024/IEC61000-4-4, Level 4, +/- 4.4kV, 100Khz rep rate, 40A, Criteria A

IEC60601-1-2, 4

Surges, Line to Line (Diff Mode) and Line

to GND (CMN Mode)

EN55024/IEC61000-4-5, Level 4, +/-2kV DM, +/-4kV CM, Criteria A

Surpasses IEC60601-1-2, 4

Conducted Disturbances induced by RF

Fields

EN55022/IEC61000-4-6, 3.6V/m – Level 4, 0.15 to 80Mhz; and 12V/m) in ISM and amateur

radio bands between 0.15Mhz and 80Mhz, 80% AM at 1KHz

IEC60601-1-2, 4

Rated Power frequency magnetic fields

EN55024/IEC1000-4-8, Level 4: 30 A/m, 50/60 Hz

IEC60601-1-2, 4th Edition, Table 4

Voltage Interruptions, Dips, Sags &

Surges

EN55024/IECEN61000-4-11: --100% dip for 20mS, Criteria A

--100% dip for 5000mS (250/300 cycles), Criteria B

--60% dip for 100mS, Criteria B

--30% dip for 500mS, Criteria A

IEC60601-1-2, 4th Edition, Table 5

Harmonic Current Emissions

EN55011/EN61000-3-2, Class A

Flicker Test

EN61000-3-3

All specifications are typical at nominal input, full load, at 25

°C ambient unless noted.

Mechanical Drawing

12V through 48V Models: 2.5 x 5.5 x 9.5mm

5V Models: Output Connector: 6 pin Molex 39-01-2060

Barrel Connector, center positive.

or equiv. Pins 1, 4 = (+), pins 3, 6 = (-), pins 2, 5 = NC

Notes:

1) All dimensions in mm.

2) 2.5mm barrel connector shown, other options are available.

3) The unit should not be covered or enclosed to protect against excessive case temperature rise.