USB4624 datasheet(17/58 Pages) MICROCHIP

17 / 58 page

USB 2.0 HSIC Hi-Speed 4-Port Hub Controller

Datasheet

 2014 Microchip Technology Inc.

DS00001717A-page 17

Port 1 HSIC

Enable

HSIC_EN1

O8/

OD8

Used to indicate the connection state to the

downstream HSIC device attached to Port 1.

0 = Disconnect Port 1 HSIC

1 = Device ready to negotiate or sustain an HSIC

connection on Port 1.

Port 2 HSIC

Enable

HSIC_EN2

O8/

OD8

Used to indicate the connection state to the

downstream HSIC device attached to Port 2.

0 = Disconnect Port 2 HSIC

1 = Device ready to negotiate or sustain an HSIC

connection on Port 2.

Port 3 Power

Output

PRTPWR3

Enables power to a downstream USB device

attached to Port 3.

0 = Power disabled on downstream Port 3

1 = Power enabled on downstream Port 3

Port 3 Control

PRTCTL3

OD8/IS

(PU)

When configured as PRTCTL3, this pin functions

as both the Port 3 power enable output

(PRTPWR3) and the Port 3 over-current sense

input (OCS3_N). Refer to the PRTPWR3 and

OCS3_N descriptions for additional information.

Port 4 Power

Output

PRTPWR4

Enables power to a downstream USB device

attached to Port 4.

0 = Power disabled on downstream Port 4

1 = Power enabled on downstream Port 4

Port 4 Control

PRTCTL4

OD8/IS

(PU)

When configured as PRTCTL4, this pin functions

as both the Port 4 power enable output

(PRTPWR4) and the Port 4 over-current sense

input (OCS4_N). Refer to the PRTPWR4 and

OCS4_N descriptions for additional information.

No Connect

This pin must be left floating for normal device

operation.

POWER

Battery

Power Supply

Input

VBAT

Battery power supply input. When VBAT is

connected directly to a +3.3V supply from the

system, the internal +3.3V regulator runs in

dropout and regulator power consumption is

eliminated. A 4.7

μF (<1

Ω ESR) capacitor to

ground is required for regulator stability. The

capacitor should be placed as close as possible

to the device. Refer to Chapter 4, "Power

Connections," on page 21 for power connection

information.

+3.3V Analog

Power Supply

VDDA33

+3.3V analog power supply. A 1.0

μF (<1

Ω ESR)

capacitor to ground is required for regulator

stability. The capacitor should be placed as close

as possible to the device. Refer to Chapter 4,

"Power Connections," on page 21 for power

connection information.

Table 3.1 Pin Descriptions (continued)

NUM PINS

NAME

SYMBOL

BUFFER

TYPE

DESCRIPTION

USB4624 Scheda tecnica(PDF) 17 Page - Microchip Technology

USB4624 Scheda tecnica(HTML) 17 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Scheda tecnica Scarica

Link URL