| Motore di ricerca datesheet componenti elettronici |
|
L6751B Scheda tecnica(PDF) 49 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
L6751B Scheda tecnica(HTML) 49 Page - STMicroelectronics |
|
49 / 58 page ![]() L6751B PMBus support (preliminary) Doc ID 024028 Rev 1 49/58 12 PMBus support (preliminary) The L6751B is compatible with PMBus™ standard revision 1.1, refer to PMBus standard documentation for further information (www.pmbus.org). Table 16. Supported commands Command Per Rail Code [Hex] Mode Comments OPERATION Y 01 RW Byte Used to turn the controller on/off in conjunction with the input from the control pin. Also used to set margin voltages. Soft off not supported ON_OFF_CONFIG N1 02 RW Byte Configures how the controller responds when power is applied WRITE_PROTECT Y 10 RW Byte Controls writing to the PMBus device to prevent accidental changes VOUT_COMMAND Y 21 RW Word Causes the converter to set its output voltage to the commanded value - VID mode VOUT_MAX Y 24 RW Word Sets the upper limit on the output voltage regardless of any other command VOUT_MARGIN_HIGH Y 25 RW Word Sets the voltage to which the output is to be changed when the OPERATION command is set to “margin high” VOUT_MARGIN_LOW Y 26 RW Word Sets the voltage to which the output is to be changed when the OPERATION command is set to “margin low” IOUT_CAL_OFFSET Y 39 RW Word Calibration for IOUT reading OT_FAULT_LIMIT Y 4F RW Word Overtemperature fault threshold OT_WARN_LIMIT Y 51 RW Word Overtemperature warning threshold VIN_OV_FAULT_LIMIT N 55 RW Word Input voltage monitor overvoltage limit VIN_UV_FAULT_LIMIT N 59 RW Word Input voltage monitor undervoltage limit MFR_SPECIFIC_01 N D1 RW Byte AVERAGE_TIME_SCALE. Sets the time between two measurements MFR_SPECIFIC_02 Y D2 RW Byte DEBUG_MODE. [01/10] Switches [ON/OFF] the Vout control on PMBus domain MFR_SPECIFIC_05 Y D5 RW Byte VOUT_TRIM. Used to apply a fixed offset voltage to the output voltage command value MFR_SPECIFIC_08 Y D8 RW Byte VOUT_DROOP. Used to change the Vout droop MFR_SPECIFIC_35 N1 F3 RW Byte MANUAL_PHASE_SHEDDING. Used to manage the phase shedding manually MFR_SPECIFIC_38 Y F6 RW Byte VOUT_OV_FAULT_LIMIT. Allows the OV protection threshold to be programmed for each rail MFR_SPECIFIC_39 Y F7 RW Byte VFDE_ENABLE MFR_SPECIFIC_40 Y F8 RW Byte ULTRASONIC_ENABLE |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |