TLP3545

2

5.

5.

5.

5. Internal Circuit

Internal Circuit

Internal Circuit

Internal Circuit

Fig.

Fig.

Fig.

Fig. 5.1

5.1

5.1

5.1 Internal Circuit

Internal Circuit

Internal Circuit

Internal Circuit

6.

6.

6.

6. Absolute Maximum Ratings (Note) (Unless otherwise specified, T

Absolute Maximum Ratings (Note) (Unless otherwise specified, T

Absolute Maximum Ratings (Note) (Unless otherwise specified, T

= 25

= 25

= 25





))))

LED

Detector

Common

Characteristics

Input forward current

Input forward current derating

Input forward current (pulsed)

Input reverse voltage

Input power dissipation

Junction temperature

OFF-state output terminal voltage

ON-state current (A connection)

ON-state current (B connection)

ON-state current (C connection)

ON-state current derating (A connection)

ON-state current derating (B connection)

ON-state current derating (C connection)

ON-state current (pulsed)

Output power dissipation

Junction temperature

Storage temperature

Operating temperature

Lead soldering temperature

Isolation voltage

(100 µs pulse, 100 pps)

(t = 100 ms, Duty = 1/10)

(10 s)

AC, 1 min, R.H. ≤ 60%

Symbol

Note

(Note 1)

(Note 1)

(Note 1)

(Note 1)

(Note 1)

(Note 1)

(Note 2)

Rating

30

-0.3

1

5

50

125

60

3

3

6

-30

-30

-60

9

500

125

-55 to 125

-40 to 85

260

2500

Unit

mA

mA/

A

V

mW



V

A

mA/

A

mW



Vrms

Note:

Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the

significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even

if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum

ratings.

Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook

("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test

report and estimated failure rate, etc).

Note 1: For an application circuit example, see Fig. 12.2.

Note 2: This device is considered as a two-terminal device: Pins 1, 2 and 3 are shorted together, and pins 4, 5 and 6

are shorted together.

2012-03-16

Rev.2.0