LP38513 datasheet(15/25 Pages) TI1

15 / 25 page

LP38513

www.ti.com

SNVS361E – JULY 2007 – REVISED NOVEMBER 2015

The maximum allowable junction temperature (TJ(MAX)) determines maximum power dissipation allowed (PD(MAX))

for the device package.

Power dissipation and junction temperature are most often related by the junction-to-ambient thermal resistance

(RθJA) of the combined PCB and device package and the temperature of the ambient air (TA), according to

Equation 5 or Equation 6:

TJ(MAX) = TA(MAX) + (RθJA × PD(MAX))

(5)

PD(MAX) = (TJ(MAX) - TA(MAX)) / RθJA

(6)

Unfortunately, this RθJA is highly dependent on the heat-spreading capability of the particular PCB design, and

therefore varies according to the total copper area, copper weight, and location of the planes. The RθJA recorded

in Thermal Information is determined by the specific EIA/JEDEC JESD51-7 standard for PCB and copper-

spreading area, and is to be used only as a relative measure of package thermal performance. For a well-

designed thermal layout, RθJA is actually the sum of the package junction-to-case (bottom) thermal resistance

(RθJCbot) plus the thermal resistance contribution by the PCB copper area acting as a heat sink.

8.2.2.4 Estimating Junction Temperature

The EIA/JEDEC standard recommends the use of psi (

Ψ) thermal characteristics to estimate the junction

temperatures of surface mount devices on a typical PCB board application. These characteristics are not true

thermal resistance values, but rather package specific thermal characteristics that offer practical and relative

means of estimating junction temperatures. These psi metrics are determined to be significantly independent of

copper-spreading area. The key thermal characteristics (

ΨJT and ΨJB) are given in Thermal Information and are

used in accordance with Equation 7 or Equation 8.

TJ(MAX) = TTOP + (ΨJT × PD(MAX))

where

•

PD(MAX) is explained in Equation 4.

•

TTOP is the temperature measured at the center-top of the device package.

(7)

TJ(MAX) = TBOARD + (ΨJB × PD(MAX))

where

•

PD(MAX) is explained in Equation 4.

•

TBOARD is the PCB surface temperature measured 1-mm from the device package and centered on the

package edge.

(8)

For more information about the thermal characteristics

ΨJT and ΨJB, see the TI Application Report:

Semiconductor and IC Package Thermal Metrics (SPRA953), available for download at www.ti.com.

For more information about measuring TTOP and TBOARD, see the TI Application Report: Using New Thermal

Metrics (SBVA025), available for download at www.ti.com.

For more information about the EIA/JEDEC JESD51 PCB used for validating RθJA, see the TI Application Report:

Thermal Characteristics of Linear and Logic Packages Using JEDEC PCB Designs (SZZA017), available for

download at www.ti.com.

Submit Documentation Feedback

Product Folder Links: LP38513

LP38513 Scheda tecnica(PDF) 15 Page - Texas Instruments

LP38513 Scheda tecnica(HTML) 15 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Scheda tecnica Scarica

Link URL