DS1920

4 of 22

STRONG PULL-UP FOR SUPPLYING DS1920 DURING TEMPERATURE

CONVERSION Figure 2

OPERATION - MEASURING TEMPERATURE

The DS1920 measures temperatures through the use of an on-board proprietary temperature measurement

technique. A block diagram of the temperature measurement circuitry is shown in Figure 3.

The DS1920 measures temperature by counting the number of clock cycles that an oscillator with a low

temperature coefficient goes through during a gate period determined by a high temperature coefficient

oscillator. The counter is preset with a base count that corresponds to -55°C. If the counter reaches 0

before the gate period is over, the temperature register, which is also preset to the -55°C value, is

incremented, indicating that the temperature is higher than -55°C.

At the same time, the counter is then preset with a value determined by the slope accumulator circuitry.

The counter is then clocked again until it reaches 0. If the gate period is still not finished, then this

process repeats.

The slope accumulator compensates for the non-linear behavior of the oscillators over temperature,

yielding a high-resolution temperature measurement. This is done by changing the number of counts

necessary for the counter to go through for each incremental degree in temperature. To obtain the desired

resolution, therefore, both the value of the counter and the number of counts per degree C (the value of

the slope accumulator) at a given temperature must be known.

Internally, this calculation is done inside the DS1920 to provide 0.5°C resolution. The temperature

reading is provided in a 16-bit, sign-extended two’s complement reading. Table 1 describes the exact

relationship of output data to measured temperature. The data is transmitted serially over the 1-Wire

interface. The DS1920 can measure temperature over the range of -55°C to +100°C in 0.5°C increments.

For Fahrenheit usage, a lookup table or conversion factor must be used.

Note that temperature is represented in the DS1920 in terms of a ½°C LSB, yielding the following 9-bit

format:

MSB

LSB

1

1

1

0

0

1

1

1

0

= -25°C