ICS1702 datasheet(4/28 Pages) ETC

4 / 28 page

ICS1702

Figure 3: Cycle-to-cycle increase of the soft-start current pulse widths

The amplitude of the current pulse is determined by system

parameters such as the current capability of the charging system,

the desired charge rate, the cell capacity and the ability of that cell

to accept the charge current. The ICS1702 can be set for nine user-

selectable fast charge rates from 15 minutes (4C) to four hours

(C/4). Charge pulses occur approximately every second. The CMN

indicator is activated continuously during this stage.

Fast Charge

In the second stage, the ICS1702 applies the charging current in a

series of charge and discharge pulses. The technique consists of a

positive current charging pulse followed by a high current, short

duration discharge pulse. The cycle, shown with charge, discharge,

rest and data acquisition periods in Figure 4, repeats every second

until the batteries are fully charged.

Figure 4: Charge cycle showing charge and discharge current pulses

Initial Pulse

Width

cycle time

Initial Pulse

Width

Initial Pulse

Width

increment

time

2 x increment

time

fast charge pulse width

acquisition tim e

rest

time

rest

time

discharge puls e width

voltage

acquisition time

temperature

time

rest

cyc le time

ICS1702 Scheda tecnica(PDF) 4 Page - List of Unclassifed Manufacturers