45W Single Output for Medical Type

WWW.ASTRODYNETDI.COM

ASTRODYNE USA: 1-800-823-8082

ASTRODYNE PACIFIC: 886-2-26983458

INPUT SPECIFICATIONS

Input Voltage Range

90-264VAC / 127-370 Volts(DC)

Frequency Range

47-440 Hz

Inrush Current, typ: (cold start)

15 Amps @ 115VAC Input

30 Amps @ 230VAC

Input Current

1.2 Amps max @ 115VAC

0.7 Amps max @ 230VAC

Leakage current

< 0.3mA / 230VAC

OUTPUT SPECIFICATIONS

Voltage and Current

See Selection Chart

Line Regulation

See Selection Chart

Load Regulation

See Selection Chart

Voltage Tolerance (Note 2)

See Selection Chart

Ripple/Noise (Note 1)

See Selection Chart

Hold Up Time @ FL

50mS @ 230VAC

16mS @ 115VAC

Setup, Rise Time @ FL

800mS, 30mS/230VAC

1200mS. 30mS/115VAC

Over Temperature Protection

Tj 135°C typ. (U1) detect on main

conrol IC, auto recover

Over Voltage Protection

115~135%

Hiccup mode, auto recover

Over Current Protection

53~75W rated output power

36~55W (3.3Volts DC)

Hiccup mode, auto recover

DC Voltage Adjust

±10%

GENERAL SPECIFICATIONS

Safety

UL2601-1

TUV EN60601-1

IEC60601-1 approved

Insulation Resistance

≥ 100MΩ / 500 Volts(DC)

EMI

Compliance to EN55011 (CISPR11)

Class B

Harmonic Current

Compliance to EN61000-3-2,-3

Efficiency

See Selection Chart

Isolation

4000VAC Input - Output

1500VAC Input - Ground

500VAC Output - Ground

EMS

Compliance to

EN61000-4-2,3,4,5,6,8,11;

ENV50204, EN55024, EN60601-1-2,

medical level, criteria A

ENVIRONMENTAL SPECIFICATIONS

Oper. Temperature

-10°C to +60°C (See Derate Curve)

Storage Temperature

-20°C to +85°C, 10~95% RH

Relative Humidity

20 to +90% RH non cond

Temperature Coefficient

0.04% / °C (0-50°C)

MTBF

366.7KHrs min, MIL-HDBK-217F(25°C)

Vibration

10~500Hz, 2G10min./1cycle, period for

60min. each along X, Y, Z axes

PHYSICAL SPECIFICATIONS

Size

Millimeters

127 x 76 x 28

Inches

5” x 2.99” x 1.10”

Weight

6.35 oz (180g)

NOTE

1. Ripple and Noise are measured at 20MHz of bandwidth by using a

12” twisted pair-wire terminated with a 0.1uf & 47 uf parallel capacitor.

2. Tolerance: includes set up tolerance, line regulation and load regula-

tion.

3. Mounting holes M1 and M2 should be grounded for EMI purposes.

All specifications are typical at nominal input, full load, and 25°C unless other-

wise noted