24AA044-ESLASHMS datasheet(5/32 Pages) MICROCHIP

5 / 32 page

 2014 Microchip Technology Inc.

DS20005286A-page 5

24AA044

2.0

PIN DESCRIPTIONS

Pin Function Table

2.1

Serial Data (SDA)

SDA is a bidirectional pin used to transfer addresses

and data into and out of the device. It is an open-drain

terminal; therefore, the SDA bus requires a pull-up

resistor to VCC (typical 10 k

 for 100 kHz, 2 k for

400kHz and 1MHz).

For normal data transfer, SDA is allowed to change

only during SCL low. Changes during SCL high are

reserved for indicating the Start and Stop conditions.

2.2

Serial Clock (SCL)

The SCL input is used to synchronize the data transfer

from and to the device.

2.3

Chip Address Inputs (A1, A2)

The levels on the A1 and A2 inputs are compared with

the corresponding bits in the slave address. The chip is

selected if the compare is true.

Up to four 24AA044 devices may be connected to the

same bus by using different Chip Select bit combina-

tions. These inputs must be connected to either VCC or

VSS.

2.4

Write-Protect (WP)

WP is the hardware write-protect pin. It must be tied to

VCC or VSS. If tied to Vcc, hardware write protection is

enabled. If WP is tied to Vss, the hardware write

protection is disabled.

2.5

Noise Protection

The 24AA044 employs a VCC threshold detector circuit

which disables the internal erase/write logic if the VCC

is below 1.35V at nominal conditions.

The SCL and SDA inputs have Schmitt Trigger and

filter circuits which suppress noise spikes to assure

proper device operation, even on a noisy bus.

3.0

FUNCTIONAL DESCRIPTION

The 24AA044 supports a bidirectional, 2-wire bus

and data transmission protocol. A device that sends

data onto the bus is defined as transmitter, while a

device receiving data is defined as receiver. The bus

has to be controlled by a master device that gener-

ates the Serial Clock (SCL), controls the bus access

and generates the Start and Stop conditions, while

the 24AA044 works as slave. Both master and slave

can operate as transmitter or receiver, but the master

device determines which mode is activated.

Name

PDIP

SOIC

TSSOP

UDFN

MSOP

Description

Not Connected

Chip Address Input

VSS

Ground

SDA

Serial Address/Data I/O

SCL

Serial Clock

Write-Protect Input

VCC

+1.7 to 5.5V Power Supply

24AA044-E/MS Scheda tecnica(PDF) 5 Page - Microchip Technology

24AA044-E/MS Scheda tecnica(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Scheda tecnica Scarica

Link URL