LP2952IMSLASHNOPB datasheet(20/41 Pages) TI1

20 / 41 page

LP2952-N, LP2952A, LP2953, LP2953A

SNVS095F – MAY 2004 – REVISED MARCH 2015

www.ti.com

Application Information (continued)

* In shutdown mode, ERROR will go high if it has been pulled up to an external supply. To avoid this invalid

response, pull up to regulator output.

** Exact value depends on dropout voltage. (See Power Supply Recommendations)

Figure 32. ERROR Output Timing

8.1.6 Output Isolation

The regulator output can be left connected to an active voltage source (such as a battery) with the regulator input

power shut off, as long as the regulator ground pin is connected to ground. If the ground pin is left floating,

damage to the regulator can occur if the output is pulled up by an external voltage source. If the regulator input

power (VIN) is applied, and the SHUTDOWN pin is low, the automatic output discharge circuit will be active, and

any voltage source applied to the output will be discharged to ground.

8.1.7 Reducing Output Noise

In reference applications it may be advantageous to reduce the ac noise present on the output. One method is to

reduce regulator bandwidth by increasing output capacitance. This is relatively inefficient, because large

increases in capacitance are required to get significant improvement.

Noise can be reduced more effectively by a bypass capacitor placed across R1 (see Figure 31). The formula for

selecting the capacitor to be used is:

(2)

This gives a value of about 0.1

μF. When this is used, the output capacitor must be 6.8 μF (or greater) to

maintain stability. The 0.1-

μF capacitor reduces the high-frequency gain of the circuit to unity, lowering the output

noise from 260

μV to 80 μV using a 10-Hz to 100-kHz bandwidth. Also, noise is no longer proportional to the

output voltage, so improvements are more pronounced at high output voltages.

Submit Documentation Feedback

Product Folder Links: LP2952-N LP2952A LP2953 LP2953A

LP2952IM/NOPB Scheda tecnica(PDF) 20 Page - Texas Instruments