P89LPC901FD datasheet(25/55 Pages) PHILIPS

25 / 55 page

Philips Semiconductors

P89LPC901/902/903

8-bit microcontrollers with two-clock 80C51 core

Product data

Rev. 04 — 21 November 2003

25 of 55

9397 750 12293

8.2.5

High speed oscillator option (P89LPC901)

This option supports an external crystal in the range of 4 MHz to 12 MHz. Ceramic

resonators are also supported in this conﬁguration. If CCLK is 8 MHz or slower, the

CLKLP SFR bit (AUXR1.7) can be set to ‘1’ to reduce power consumption. On reset,

CLKLP is ‘0’ allowing highest performance access. This bit can then be set in

software if CCLK is running at 8 MHz or slower.

8.2.6

Clock output (P89LPC901)

The P89LPC901 supports a user selectable clock output function on the

XTAL2/CLKOUT pin when crystal oscillator is not being used. This condition occurs if

another clock source has been selected (on-chip RC oscillator, Watchdog oscillator,

external clock input on X1) and if the Real-Time clock is not using the crystal

oscillator as its clock source. This allows external devices to synchronize to the

P89LPC901. This output is enabled by the ENCLK bit in the TRIM register. The

frequency of this clock output is 1

⁄

2 that of the CCLK. If the clock output is not needed

in Idle mode, it may be turned off prior to entering Idle, saving additional power.

8.3 On-chip RC oscillator option

The P89LPC901/902/903 has a 6-bit TRIM register that can be used to tune the

frequency of the RC oscillator. During reset, the TRIM value is initialized to a factory

pre-programmed value to adjust the oscillator frequency to 7.373 MHz,

±2.5%.

End-user applications can write to the Trim register to adjust the on-chip RC oscillator

to other frequencies. If CCLK is 8 MHz or slower, the CLKLP SFR bit (AUXR1.7) can

be set to ‘1’ to reduce power consumption. On reset, CLKLP is ‘0’ allowing highest

performance access. This bit can then be set in software if CCLK is running at 8 MHz

or slower.

8.4 Watchdog oscillator option

The Watchdog has a separate oscillator which has a frequency of 400 kHz. This

oscillator can be used to save power when a high clock frequency is not needed.

8.5 External clock input option (P89LPC901)

In this conﬁguration, the processor clock is derived from an external source driving

the XTAL1/P3.1 pin. The rate may be from 0 Hz up to 12 MHz. The XTAL2/P3.0 pin

may be used as a standard port pin or a clock output.

P89LPC901FD Scheda tecnica(PDF) 25 Page - NXP Semiconductors

P89LPC901FD Scheda tecnica(HTML) 25 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

Scheda tecnica Scarica

Link URL