EMC2103 datasheet(21/85 Pages) MICROCHIP

21 / 85 page

RPM-Based Fan Controller with Hardware Thermal Shutdown

Datasheet

DS0005250A-page 21

 2013 Microchip Technology Inc.

Note: The shaded columns represent data sent from the EMC2103 to the EEPROM device.

APPLICATION NOTE: It is recommended that the EEPROM that is used be an AT24C02B or equivalent device.

The EEPROM slave address must be 1010_000xb. The device must support a block-read

command, 8-bit addressing, and 8-bit data formatting using a 2-wire bus. The device must

support 3.3V digital switching logic and may not pull the SMCLK and SMDATA pins above

5V. Data must be transmitted MSB first.

APPLICATION NOTE: No other SMBus Master should exist on the SMDATA and SMCLK lines. The presence of

another SMBus Master will cause errors in reading from the EEPROM.

The EEPROM should be loaded to mirror the register set of the EMC2103 with the desired

configuration set. All undefined registers in the EMC2103 register set should be loaded with 00h in the

EEPROM. Likewise, all registers that are read-only in the EMC2103 register set should be loaded with

00h in the EEPROM.

Because of the interaction between the Fan Control Look-up Tables and the Fan Configuration

these registers at the end of the EEPROM loading cycle.

EMC2103 Scheda tecnica(PDF) 21 Page - Microchip Technology