SI5341_16 datasheet(8/53 Pages) SILABS

8 / 53 page

3.3.3 Input Selection (IN0, IN1, IN2, XA/XB)

The active clock input is selected using the IN_SEL[1:0] pins or by register control. A register bit determines input selection as pin or

Table 3.1. Manual Input Selection Using IN_SEL[1:0] Pins

IN_SEL[1:0]

Selected Input

IN0

IN1

IN2

XA/XB

3.4 Fault Monitoring

The Si5340/41-D provides fault indicators which monitor loss of signal (LOS) of the inputs (IN0, IN1, IN2, XA/XB, FB_IN) and loss of

lock (LOL) for the PLL as shown in the figure below.

PLL

LPF

IN0

IN0b

LOS0

÷P0

IN1

IN1b

÷P1

FB_IN

FB _INb

IN2

IN2b

÷P2

LOL

Si5341/40

OSC

÷Pfb

LOSXAB

LOS1

LOS2

LOSFB

Figure 3.4. LOS and LOL Fault Monitors

3.4.1 Status Indicators

The state of the status monitors are accessible by reading registers through the serial interface or with dedicated pin (LOLb). Each of

the status indicator register bits has a corresponding sticky bit in a separate register location. Once a status bit is asserted its corre-

sponding sticky bit (_FLG) will remain asserted until cleared. Writing a logic zero to a sticky register bit clears its state.

3.4.2 Interrupt Pin (INTRb)

An interrupt pin (INTRb) indicates a change in state with any of the status registers. All status registers are maskable to prevent asser-

tion of the interrupt pin. The state of the INTRb pin is reset by clearing the status registers.

Si5341/40 Rev D Data Sheet

Functional Description

silabs.com | Smart. Connected. Energy-friendly.

Rev. 1.0 | 7

SI5341 Scheda tecnica(PDF) 8 Page - Silicon Laboratories

SI5341 Scheda tecnica(HTML) 8 Page - Silicon Laboratories

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

Scheda tecnica Scarica

Link URL