MIC28512 datasheet(22/34 Pages) MICROCHIP

22 / 34 page

MIC28512

DS20005524A-page 22

 2016 Microchip Technology Inc.

5.0

APPLICATION INFORMATION

5.1

Output Voltage Setting

Components

The MIC28512 requires two resistors to set the output

voltage as shown in Figure 5-1.

FIGURE 5-1:

Voltage Divider

Configuration.

The output voltage is determined by Equation 5-1.

EQUATION 5-1:

A typical value of R1 used on the standard evaluation

board is 10 kΩ. If R1 is too large, it may allow noise to

be introduced into the voltage feedback loop. If R1 is

too small in value, it will decrease the efficiency of the

power supply, especially at light loads. Once R1 is

selected, R2 can be calculated using Equation 5-2:

EQUATION 5-2:

5.2

Setting the Switching Frequency

The MIC28512 switching frequency can be adjusted

between 200 kHz and 680 kHz by changing the resistor

divider network from VIN.

FIGURE 5-2:

Switching Frequency

Adjustment.

Equation 5-3 gives the estimated switching frequency.

EQUATION 5-3:

Figure 5-3 shows the switching frequency versus the

resistor R4 when R3 = 100 kΩ.

FIGURE 5-3:

Switching Frequency vs. R4.

5.3

Inductor Selection

Values for inductance, peak, and RMS currents are

required to select the output inductor. The input and

output voltages and the inductance value determine

the peak-to-peak inductor ripple current. Generally,

higher inductance values are used with higher input

voltages. Larger peak-to-peak ripple currents will

increase the power dissipation in the inductor and

M AMP

REF

OUT

-------







Where:

VFB

0.8V



OUT

–

-----------------------------

--------------------







Where:

Switching frequency when R4 is open;

typically 680 kHz.

MIC28512 Scheda tecnica(PDF) 22 Page - Microchip Technology

MIC28512 Scheda tecnica(HTML) 22 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Scheda tecnica Scarica

Link URL