Bussmann series HEB breakaway and non-breakaway

in-line fuse holders for UL 13/32” x 1-1/2” supplemental fuses

Technical Data 2127

Effective October 2015

Eaton

1000 Eaton Boulevard

Cleveland, OH 44122

Eaton.com

Bussmann Division

114 Old State Road

Ellisville, MO 63021

United States

Eaton.com/bussmannseries

© 2015 Eaton

All Rights Reserved

Printed in USA

Publication No. 2127 - BU-SB15154

December 2015

Eaton, Bussmann and Tron are valuable

trademarks of Eaton in the US and other

countries. You are not permitted to use the

Eaton trademarks without prior written

consent of Eaton.

CSA is a registered trademark of the

Canadian Standards Group.

Sta-Kon is a registered trademark of

Thomas & Betts.

UL is a registered trademark of the

Underwriters Laboratories, Inc.

The only controlled copy of this data sheet is the electronic read-only version located on the Eaton network drive. All other copies of this

document are by definition uncontrolled. This bulletin is intended to clearly present comprehensive product data and provide technical

information that will help the end user with design applications. Eaton reserves the right, without notice, to change design or construction of

any products and to discontinue or limit distribution of any products. Eaton also reserves the right to change or update, without notice, any

technical information contained in this bulletin. Once a product has been selected, it should be tested by the user in all possible applications.

Recommended crimping tools:

A wide variety of crimping tools can be used with the HEB fuse

holders. Some of the commercially available tools are listed in

the table below. This list is not intended to exclude the use of

other crimping tools that can provide similar crimps or indents.

HEB terminal

T & B P/N (Die)

A

WT-111M (Die C)

B

WT-115A (Die D)

C

TBM5 (Grey Die)

WT-115A (Die E)

D

TBM5 (Brown Die)

TBM8 (Brown Die)

WT-115A (Die F)

Z

WT-111M (Die A)

Sta-Kon ERG4002 (Die A)

N, P, Q, R, T

TBM8 (Orange Die)