KP1510HTL datasheet(5/14 Pages) COSMO

5 / 14 page

Cosmo Electronics Corp.

Document No. 69P51006.2

- 5 -

http://www.cosmo-ic.com

cosmo

KP1510 Series

8PIN IGBT GATE DRIVE

PHOTOCOUPLER



Switching Characteristics

(Ta = 25℃)

Parameter

Symbol

Test Condition

Min.

Typ.

Max.

Unit

Propagation delay

time

“L→H”

tpLH

IF=7mA to 16mA

Rg=10Ω,Cg=10nF

F=10KHz,Duty Cycle=50%

0.1

0.3

0.5

“H→L”

tpHL

0.1

0.3

0.5

Pulse width distortion

tPhl- tpLH

PWD

—

0.3

Propagation delay difference

Between AnyTwo Parts or

Channels (tPhl- tPlh)

(7)

PDD

(Skew)

-0.35

—

0.35

Output rise time (10%-90%)

—

0.1

—

Output fall time

—

0.1

—

UVLO turn-on delay

TUVLO ON

IF =10mA, VO>5V

—

0.8

—

UVLO turn-off delay

TUVLO OFF IF =10mA, VO<5V

—

0.6

—

Common mode transient

immunity at high level output

∣CMH∣

TA=25 ,V

℃ CC=30V,

IF=10mA to 16mA VCM=1500V

(8)

—

KV / μs

Common mode transient

immunity at low level output

∣CML∣

TA=25 ,V

℃ CC=30V,

VF=0V VCM=1500V

(9)

—

KV / μs

Notes:

1. Maximum pulse width = 10μs, maximum duty cycle = 1.1%

2. Derate linearly above 87°C, free air temperature at a rate of 0.77mW/°C

3. No derating required across temperature range.

4. Functional operation under these conditions is not implied. Permanent damage may occur if the device is

subjected to conditions outside these ratings.

5. Device is considered a two terminal device: Pins 2 and 3 are shorted together and Pins 5, 6, 7 and 8 are shorted

together.

6. 5,000 VRMS for 1 minute duration is equivalent to 6,000 VACRMS for 1 second duration.

7. The difference between tPHL and tPLH between any two KP1510 parts under same test conditions.

8. Common mode transient immunity at output high is the maximum tolerable negative dVcm/dt on the trailing edge

of the common mode impulse signal, Vcm, to assure that the output will remain high (i.e. VO > 15.0V).

9. Common mode transient immunity at output low is the maximum tolerable positive dVcm/dt on the leading edge of

the common pulse signal, Vcm, to assure that the output will remain low (i.e. VO < 1.0V).

10. Pulse Width, PW 1μs, 300pps

11. Exponential Waveform, IO(PEAK) ≦2.5A (≦0.3μs)

KP1510HTL Scheda tecnica(PDF) 5 Page - COSMO Electronics Corporation

KP1510HTL Scheda tecnica(HTML) 5 Page - COSMO Electronics Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Scheda tecnica Scarica

Link URL