ATtiny11 datasheet(49/61 Pages) ATMEL

49 / 61 page

Using AVR Studio

AVR STK500 User Guide

5-9

1925C–AVR–3/03

5.4

Command Line

Software

The DOS command line version of the STK500 software is useful for programming

STK500 from external editors or for use in production programmers. Simple batch files

can be made for automatic programming. Type “STK500 -?” for help.

The program returns ERRORCODE 0 if the operation was successful, and ERROR-

CODE 1 if the operation failed.

Command Line Switches:

[-d device name] [-m s|p] [-if infile] [-ie infile] [-of outfile]

[-oe outfile] [-s] [-O] [-Sf addr] [-Seaddr] [-e] [-p f|e|b]

[-r f|e|b] [-v f|e|b] [-l value] [-L value] [-y] [-f value] [-E value]

[-F value] [-G value] [-q] [-x value] [-af start,stop] [-ae start,stop]

[-c port] [-ut value] [-ua value] [-wt] [-wa] [-b h|s] [-! freq] [-t]

[-g] [-z] [-h|?]

5.5

Parameters

Device name. Must be applied when programming the device. See list below.

Select programming mode; serial (s) or parallel/High-voltage (p).

Serial programming mode is the default, and is used if this parameter not

applied.

Name of FLASH input file. Required for programming or verification of the FLASH

memory. The file format is Intel Extended HEX.

Name of EEPROM input file. Required for programming or verification of the

EEPROM memory. The file format is Intel Extended HEX.

Name of flash output file. Required for readout of the FLASH memory. The file

format is Intel Extended HEX.

Name of EEPROM output file. Required for readout of the EEPROM memory. The

file format is Intel Extended HEX.

Read signature bytes.

Read oscillator calibration byte.

Write oscillator call. byte to FLASH memory. “addr” is byte address

Write oscillator call. byte to EEPROM memory. “addr” is byte address

Erase device. If applied with another programming parameter, the device will be

erased before any other programming takes place.

Program device; FLASH (f), EEPROM (e) or both (b). Corresponding input files

are required.

Read out device; FLASH (f), EEPROM (e) or both (b). Corresponding output files

are required

Verify device; FLASH (f), EEPROM (e) or both (b). Can be used with -p or stand

alone. Corresponding input files are required.

Set lock byte. “value' is an 8-bit hex. value.

Verify lock byte. “value” is an 8-bit hex. value to verify against.

Read back lock byte.

ATtiny11 Scheda tecnica(PDF) 49 Page - ATMEL Corporation

ATtiny11 Scheda tecnica(HTML) 49 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

Scheda tecnica Scarica

Link URL