CP10.241, CP10.242, CP10.241-S1

CP-Series

This feature monitors the output voltage on the output terminals of a running power supply.

Contact closes

As soon as the output voltage reaches typ. 90% of the adjusted output voltage level.

Contact opens

As soon as the output voltage dips more than 10% below the adjusted output voltage.

Short dips will be extended to a signal length of 100ms. Dips shorter than 1ms will be ignored.

Contact ratings

max.

60Vdc 0.3A, 30Vdc 1A, 30Vac 0.5A

resistive load

min.

1mA at 5Vdc

min. permissible load

Isolation voltage

See dielectric strength table in section 18.

Fig. 8-1 DC-ok relay contact behavior

100ms

0.9* V

ADJ

<

1ms

10%

9/27

open

V

open

closed

closed

>

1ms

Feb. 2016 / Rev. 1.3 DS-CP10.241-EN

All parameters are specified at 24V, 10A, 230Vac, 50Hz, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany