CS10.481

C-Line

Page

Page

1.

Intended Use .......................................................3

2.

Installation Requirements...................................4

3.

AC-Input...............................................................5

4.

DC-Input...............................................................7

5.

Input Inrush Current ...........................................7

6.

Output .................................................................8

7.

Hold-up Time.......................................................9

8.

Efficiency and Power Losses..............................10

9.

Lifetime Expectancy and MTBF.........................11

10. Functional Diagram...........................................11

11. Terminals and Wiring........................................12

12. Front Side and User Elements...........................13

13. EMC....................................................................14

14. Environment ......................................................15

15. Protection Features ...........................................16

16. Safety Features ..................................................16

17. Dielectric Strength ............................................17

18. Approvals...........................................................18

19. RoHS, REACH and Other Fulfilled Standards ...18

20. Physical Dimensions and Weight ..................... 19

21. Accessories ........................................................ 20

21.1. ZM1.WALL - Wall Mounting Bracket.......20

21.2. ZM13.SIDE - Side Mounting Bracket........20

21.3. Redundancy Modules ...............................21

22. Application Notes............................................. 22

22.1. Peak Current Capability ...........................22

22.2. Back-feeding Loads ..................................23

22.3. External Input Protection.........................23

22.4. Output Circuit Breakers............................23

22.5. Parallel Use to Increase Output Power....24

22.6. Parallel Use for Redundancy ....................24

22.7. Series Operation .......................................24

22.8. Inductive and Capacitive Loads................24

22.9. Charging of Batteries ...............................25

22.10. Operation on Two Phases ........................25

22.11. Use in a Tightly Sealed Enclosure ............25

22.12. Mounting Orientations ............................26

The information presented in this document is believed to be accurate and reliable and may change without notice.

No part of this document may be reproduced or utilized in any form without permission in writing from the publisher.

PE and

symbol

PE is the abbreviation for Protective Earth and has the same meaning as the symbol

.

Earth, Ground

This document uses the term “earth” which is the same as the U.S. term “ground”.

T.b.d.

To be defined, value or description will follow later.

AC 230V

A figure displayed with the AC or DC before the value represents a nominal voltage with

standard tolerances (usually ±15%) included.

E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)

230Vac

A figure with the unit (Vac) at the end is a momentary figure without any additional

tolerances included.

50Hz vs. 60Hz

As long as not otherwise stated, AC 100V and AC 230V parameters are valid at 50Hz mains

frequency. AC 120V parameters are valid for 60Hz mains frequency.

may

A key word indicating flexibility of choice with no implied preference.

shall

A key word indicating a mandatory requirement.

should

A key word indicating flexibility of choice with a strongly preferred implementation.

Jul. 2015 / Rev. 2.0 DS-CS10.481-EN

All parameters are specified at 48V, 5A, 230Vac, 50Hz, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

2/26