SPECIFICATION 55PC, ISSUE 8

Page 17 of 18

NOTE:

ANY PRINTED COPY OF THIS DOCUMENT

IS AN UNCONTROLLED COPY.

© 2008-2015 Tyco Electronics Corporation. All rights reserved.

5.2

LABELING REQUIREMENTS

All spools and reels shall be identified with the following information:

Manufacturer's Part Number

Lot Number

Quantity in Feet (or Meters)

Name of Manufacturer

6.

APPLICABLE DOCUMENTS

6.1

GOVERNMENT-FURNISHED DOCUMENTS

The following documents, of the issue in effect on date of invitation for bids or request for

proposal, form a part of this specification to the extent specified herein.

6.1.1

Department of Defense

SPECIFICATIONS

Federal

UU-T-450

Tissue, Facial

STANDARDS

Military

MIL-STD-104

Limits for Electrical Insulation Color

MIL-STD-1916

DOD Preferred Methods for Acceptance of Product

(Copies of Department of Defense documents may be obtained from the Naval Publications

and Forms Center, Standardization Documents Order Desk, Bldg. 4D, 700 Robbins Ave.,

6.2

OTHER PUBLICATIONS

The following documents, of the issue in effect on date of invitation for bids or request for

proposal, form a part of this specification to the extent specified herein.

6.2.1

American Society for Testing and Materials (ASTM)

B 193

Standard Test Method for Resistivity of Electrical Conductor Materials

D 3032

Standard Test Methods for Hookup Wire Insulation

(Copies of ASTM documents may be obtained from the American Society for Testing and

Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959; or at