slad4e100 / 071026

3/ 4

SLAD4.100

Data sheet

Connectors and terminals

Front elements

Terminals

Fingertouch-proof terminals with captive

screws for 5.5 mm slotted screwdriver or Philips

cross-recessed screwdriver No. 2

Position

Easy to reach terminals on the front panel;

Input and output clearly separate from each

other

Tightening torque

0.8 Nm

Wire gauge

• flexible cable

• solid cable

Ferrules

Admissible

Stripping length

7mm

Input DC 24V

+ Input

- Input

Chassis Ground Ground this terminal to minimize high-frequency

emissions.

Output DC 30.5V /4A

brown

Positive AS-Interface output voltage (twice)

blue

Negative AS-Interface output voltage (twice)

Shield

Connection of machine ground.

Functional earth for balancing the AS-Interface out-

put. Connection is recommended for EMC purpose

Construction / Mechanics

Installation notes

Housing

Robust metal housing for built-in installation

Degree of protection

IP20 (EN 60529)

Class of protection

1 (IEC 60536)

Width w

Height h

Depth d

40mm

124mm

102mm (without DIN rail)

Weight

Appr. 500g

External fusing

Not necessary (internal fuse)

Mounting position

Vertical; input below, output above

Free space for

cooling

Above / below 25mm recommended

Left / right 15mm recommended

Operation without AS-Interface:

This AS-Interface DC/DC converter has an inductive output. When op-

erating without AS-Interface structure (e.g. in a laboratory test) you

should connect a 470µF / 35V capacitor between AS-Interface + and AS-

Interface - as commercial electronic loads in combination with the data

decoupling often tend to oscillate, and the oscillation may exceed the

permitted modulation voltage.

Otherwise, equipment may be destroyed.

Operating indicators and elements

DIN-rail mouting bracket

Plastic slider:

• Mounting: Place the unit onto the DIN-rail and push it down-

wards and against the lower front edge until it snaps into place.

• Detachment: Push downwards and detach the unit from its DIN-

rail mounting bracket.

Output terminals:

Dual terminals for

AS-Interface + and

AS-Interface –

Input terminals

Machine ground

connection

Green LED:

ON: AS-Interface voltage is

within the limits.

OFF: at overload or

missing input voltage

Plastic slider