WM8510GEDSSLASHV datasheet(30/56 Pages) WOLFSON

Il numero della parte	WM8510GEDS/V

Spiegazioni elettronici	MONO CODEC WITH SPEAKER DRIVER

PDF	56 Pages

Scroll/Zoom	100%

Produttore elettronici	WOLFSON [Wolfson Microelectronics plc]

Homepage	http://www.wolfsonmicro.com

Logo

30 / 56 page

WM8510

Product Preview

PP Rev 1.2 December 2004

ANALOGUE OUTPUTS

The WM8510 has a single MONO output and two outputs SPKOUTP and SPOUTN for driving a

mono BTL speaker. These analogue output stages are supplied from SPKVDD and are capable of

driving up to 1.5V rms signals (equivalent to 3V rms into a bridge tied speaker) as shown in Figure

15.

Figure 15 Speaker and Mono Analogue Outputs

The Mono and speaker outputs have output driving stages which can be controlled by the register

bits MONOBOOST and SPKBOOST respectively. Each output stage has a selectable gain boost of

1.5x.

When this boost is enabled the output DC level is also level shifted (from AVDD/2 to

1.5xAVDD/2) to prevent the signal from clipping. A dedicated amplifier, as shown in Figure 15, is

used to perform the DC level shift operation. This buffer must be enabled using the BUFDCOPEN

than 1.5xAVDD this boost mode may result in signals clipping. Table 13 summarises the effect of

the SPKBOOST/MONOBOOST control bits.

WM8510GEDS/V Scheda tecnica(PDF) 30 Page - Wolfson Microelectronics plc