IOBUS0 datasheet(51/88 Pages) FTDI

51 / 88 page

C opyright © Future T ec hnology Devic es I nternational Limited

Datasheet

Vinculum-II Embedded Dual USB Host Controller IC

V ers ion 1 .7

Doc ument N o.: FT _000138 C learance N o.: FT DI# 1 43

Status Bit

Meaning

New Data

Data in current transaction is valid data.

Byte removed from Transmit Buffer.

Old Data

This same data has been read in a previous read cycle.

Repeat the read cycle until New Data is received.

Table 6.10 SPI Master Data Read Status Bit

Figure 6.17 SPI Master Data Read (VNC2 Slave Mode)

The status bit is only valid until the next rising edge of SCLK after the last data bit.

During the Data Read operation the SS signal must not be de-asserted.

The transfer completes after 12 clock cycles and the next transfer can begin when MOSI and SS are high

during the rising edge of SCLK.

6.3.6.3 SPI Master Data Write Transaction in VNC1L legacy mode

During an SPI master Data Write operation the Start and Setup sequence is sent by the SPI master to

VNC2, see Figure 6.18. This is followed by the SPI master transmitting each bit of the data to be written

to VNC2. The VNC2 then responds with a status bit on MISO on the rising edge of the next clock cycle.

The SPI master must read the status bit at the end of each write transaction to determine if the data was

written successfully to VNC2 Receive Buffer. The Data Write status bit is defined in Table 6.11.The

status bit is only valid until the next rising edge of SCLK after the last data bit.

If the status bit indicates Accept then the byte transmitted has been added to VNC2 Receive Buffer. If it

shows Reject then the Receive Buffer is full and the byte of data transmitted in the current transaction

should be re-transmitted by the SPI master to VNC2.

Any application should poll VNC2 Receive Buffer by retrying the Data Write operation until the data is

accepted.

Status Bit

Meaning

Data from the current transaction was accepted and added to the Receive Buffer

Reject

Write data was not accepted. Retry the same write cycle.

Table 6.11 SPI Master Data Write Status Bit

IOBUS0 Scheda tecnica(PDF) 51 Page - Future Technology Devices International Ltd.