LM12434CIWM datasheet(63/80 Pages) NSC

Il numero della parte	LM12434CIWM

Spiegazioni elettronici	Sign Data Acquisition System with Serial I/O and Self-Calibration

PDF	80 Pages

Scroll/Zoom	100%

Produttore elettronici	NSC [National Semiconductor (TI)]

Homepage	http://www.national.com

Logo

63 / 80 page

70 Digital Interface (Continued)

Burst read cycle

A burst read cycle starts the same way

as a single read cycle but the B bit in the command packet

is set to one indicating a burst read cycle After the first 16

bits of data carrying the command packet is written to the

DAS the DAS begins to send out the data words from the

addressed register on the DR line repeatedly Each data

word is preceded by an FSR pulse for synchronization To

terminate a burst read cycle the processor does a dummy

read from the configuration register during the last

data word This dummy read should be started so that its

FSR pulse occurs during the 15th to 17th SCLK cycle of the

last data word as shown in

Figure 15c The dummy read

terminates the burst read cycle and shifts out the contents

of the configuration register on the DR line This data can be

discarded After transfer of the last data bit from the config-

uration register the DAS is ready for a new communication

cycle to begin

TLH11879 – 47

(a) Write Cycle

TLH11879 – 48

(b) Read Cycle

FIGURE 15 Timing Diagram for LM12434 and LM12 L 438 TMS320 Serial Interface Mode

LM12434CIWM Scheda tecnica(PDF) 63 Page - National Semiconductor (TI)