ACPL-P302 datasheet(7/15 Pages) BOARDCOM

7 / 15 page

Broadcom Confidential

- 7 -

ACPL-P302/ACPL-W302

Data Sheet

Package Characteristics

Parameter

Symbol

Device

Min.

Typ.

Max.

Unit

Test Conditions

Fig.

Note

Input-Output Momentary

Withstand Voltage

VISO

ACPL-P302

3750

Vrms

TA = 25°C,

RH < 50% for 1 min.

8, 10

ACPL-W302

5000

9, 10

Input-Output Resistance

RI-O

1012

VI-O = 500V

Input-Output Capacitance

CI-O

0.6

Freq=1 MHz

Notes:

1. Derate linearly above 70°C free air temperature at a rate of 0.3 mA/°C.

2. Maximum pulse width = 10 μs, maximum duty cycle = 0.2%. This value is intended to allow for component tolerances for designs with IO peak minimum = 0.2A.

See Application section for additional details on limiting IOL peak.

3. Derate linearly above 85°C, free air temperature at the rate of 4.0 mW/°C.

4. Input power dissipation does not require derating.

5. Maximum pulse width = 50 μs, maximum duty cycle = 0.5%.

6. In this test, VOH is measured with a DC load current. When driving capacitive load VOH will approach VCC as IOH approaches zero amps.

7. Maximum pulse width = 1 ms, maximum duty cycle = 20%.

8. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage > 4500VRMS for 1 second (leakage detection current limit

II-O < 5 μA). This test is performed before 100% production test for partial discharge (method B) shown in the IEC/EN/DIN EN 60747-5-5 Insulation Characteristics

Table, if applicable.

9. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage > 6000VRMS for 1 second (leakage detection current limit II-O

< 5A). This test is performed before 100% production test for partial discharge (method B) shown in the IEC/EN/DIN EN 60747-5-5 Insulation Characteristics Table,

if applicable.

10. Device considered a two-terminal device: pins on input side shorted together and pins on output side shorted together.

11. PDD is the difference between tPHL and tPLH between any two parts or channels under the same test conditions.

12. Common mode transient immunity in the high state is the maximum tolerable |dVCM/dt| of the common mode pulse VCM to assure that the output will remain

in the high state (i.e. VO > 15.0 V).

13. Common mode transient immunity in a low state is the maximum tolerable |dVCM/dt| of the common mode pulse, VCM, to assure that the output will remain in

a low state (i.e. VO < 1.0 V).

14. This load condition approximates the gate load of a 1200 V/20 A IGBT.

15. The power supply current increases when operating frequency and Qg of the driven IGBT increases.

ACPL-P302 Scheda tecnica(PDF) 7 Page - Broadcom Corporation.

ACPL-P302 Scheda tecnica(HTML) 7 Page - Broadcom Corporation.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Scheda tecnica Scarica

Link URL