AXC F XT ETH 1TX

107237_en_01

PHOENIX CONTACT

7 / 12

7Mounting

7.1

Removing the controller supply connector

•

Release the locking latch (A), tilt the supply connector

upwards slightly (B), and remove it from the controller

(C).

Figure 3

Removing the supply connector

7.2

Removing other connectors from the controller

•

Remove all other connectors from the controller.

7.3

Removing electronics modules

Before the left-alignable Ethernet interface can be aligned to

the controller, you must remove the controller electronics

module.

In the case of AXC ... controllers, you must also remove the

electronics module of the first module aligned to the right.

To do this, proceed as follows:

•

Insert a suitable tool (e.g., bladed screwdriver) into the

upper and lower snap-on mechanisms (base latches) of

the controller/module one after the other and release it

(A).

The base latches are locked in place in the open position.

•

Remove the electronics module vertically out of the DIN

rail (B).

Figure 4

Removing the electronics module

To operate the left-alignable Ethernet interface on a

controller for Axioline F, a special bus base module is

required for the respective controller.

The bus base module is not supplied as standard with

AXC ... controllers. For the ordering data, please refer to the

user manual for the controller you are using.

In the case of AXC ... controllers, you must first replace the

existing bus base module with the special bus base module.

To do this, proceed as follows:

•

Remove the controller bus base module from the bus

base of the first module aligned to the right.

•

Remove the controller bus base module from the DIN

rail.

Proceed as follows to mount the special bus base module:

Please note:

Mount all the modules required before

supplying power to the Axioline F station.

Modules to which power is only supplied

following the controller boot process are not

detected or may result in a malfunction.

To ensure that the left-alignable Ethernet

interface is detected correctly, proceed as

follows:

– Switch on the power to the left-alignable

Ethernet interface before switching on the

power to the controller

OR

– Switch on the power to the left-alignable

Ethernet interface and to the controller

simultaneously.

A

A

B