M69KB096AA datasheet(14/48 Pages) STMICROELECTRONICS

Il numero della parte	M69KB096AA

Spiegazioni elettronici	64 Mbit (4M x16) 1.8V Supply, 80MHz Clock Rate, Burst PSRAM

PDF	48 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

14 / 48 page

M69KB096AA

14/48

Figure 8. Set Configuration Register (Software Method)

Note: 1. Only the Bus Configuration Register (BCR) and the Refresh Configuration Register (RCR) can be modified.

2. To program the BCR or the RCR on last bus write cycle, DQ0-DQ15 must be set to ‘0001h’ and ‘000h’ respectively.

3. The highest order address location is not modified during this operation.

4. The third write operation must be controlled by the Chip Enable signal.

Figure 9. Read Configuration Register (Software Method)

Note: 1. To read the BCR, RCR on last bus read cycle, DQ0-DQ15 must be set to ‘0001h’, ‘000h’ respectively.

2. The highest order address location is not modified during this operation.

3. The Chip Enable signal, E, must be held High for 150ns before reading the content of the Configuration Register.

4. The third write operation must be controlled by the Chip Enable signal.

Addr.

3FFFFFh

LB, UB

AI10600b

3FFFFFh

DQ0-DQ15

(2)

CR Data IN

tEHEL2

Don't Care

(4)

Addr.

3FFFFFh

LB, UB

AI10601b

3FFFFFh

DQ0-DQ15

(1)

CR Data

OUT

tEHEL2

Don't Care

(3)

M69KB096AA Scheda tecnica(PDF) 14 Page - STMicroelectronics