AS5043 datasheet(14/26 Pages) AMSCO

14 / 26 page

AS5043 Programmable 360° Magnetic Angle Encoder

Revision 1.4, 04-Apr-06

www.austriamicrosystems.com

Page 14 of 26

13 Analog Readback Mode

Non-volatile programming (OTP) uses on-chip zener

diodes, which become permanently low resistive when

subjected to a specified reverse current.

The quality of the programming process depends on the

amount of current that is applied during the programming

process (up to 130mA). This current must be provided by

an external voltage source. If this voltage source cannot

provide adequate power, the zener diodes may not be

programmed properly.

In order to verify the quality of the programmed bits, an

analog level can be read for each zener diode, giving an

indication whether this particular bit was properly

programmed or not.

To put the AS5043 in Analog Readback Mode, a digital

sequence must be applied to pins CSn, PROG and CLK

as shown in Figure 15. The digital level for this pin

depends on the supply configuration (3.3V or 5V; see

section 7, page 4).

The second rising edge on CSn (OutpEN) changes pin

PROG to a digital output and the log. high signal at pin

PROG must be removed to avoid collision of outputs

(grey area in Figure 15).

The following falling slope of CSn changes pin PROG to

an analog output, providing a reference voltage Vref, that

must be saved as a reference for the calculation of the

subsequent programmed and unprogrammed OTP bits.

Following this step, each rising slope of CLK outputs one

bit of data in the reverse order as during programming.

(see Figure 15: Output Range OR0 and -1 , ClampMdEn,

RefExtEn, FB_IntEn, Z0…Z9, ccw)

During analog readback, the capacitor at pin PROG (see

Figure 12) should be removed to allow a fast readout

rate.

The measured analog voltage for each bit must be

subtracted from the previously measured Vref, and the

resulting value gives an indication on the quality of the

programmed bit: a reading of <100mV indicates a

properly programmed bit and a reading of >1V indicates

a properly unprogrammed bit.

A reading between 100mV and 1V indicates a faulty bit,

which may result in an undefined digital value, when the

OTP is read at power-up.

Following the 16th clock (after reading bit “ccw”), the chip

must be reset by disconnecting the power supply.

In te rn a l

te st b it

digita l

V unprogram m ed

V programmed

CS n

CL K

PR O G

Pro g EN

OR 1

OR 0

A nalo g R e a dba c k D a ta at P R O G

Ou tp E N

tLoadProg

CL K Aread

P rog c h a nges to O u tp ut

V ref

P ow er-on-

Re s e t;

cyc le

s upp ly

Re fE xt

Cla m p

Md E N

ccw

Figure 15:Analog OTP Register Read

AS5043 Scheda tecnica(PDF) 14 Page - ams AG

AS5043 Scheda tecnica(HTML) 14 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Scheda tecnica Scarica

Link URL