LPC2364 datasheet(28/48 Pages) PHILIPS

28 / 48 page

LPC2364_66_68_1

Preliminary data sheet

Rev. 01 — 22 September 2006

28 of 48

Philips Semiconductors

LPC2364/2366/2368

Fast communication chip

whenever any of the aforementioned functions are turned off for any reason. Since the

oscillator and other functions are turned off during Power-down mode, any wake-up of the

processor from Power-down mode makes use of the wake-up Timer.

The Wake-up Timer monitors the crystal oscillator to check whether it is safe to begin

code execution. When power is applied to the chip, or when some event caused the chip

to exit Power-down mode, some time is required for the oscillator to produce a signal of

sufficient amplitude to drive the clock logic. The amount of time depends on many factors,

including the rate of VDD ramp (in the case of power on), the type of crystal and its

electrical characteristics (if a quartz crystal is used), as well as any other external circuitry

(e.g. capacitors), and the characteristics of the oscillator itself under the existing ambient

conditions.

7.24.4 Power control

The LPC2364/66/68 supports a variety of power control features. There are four special

modes of processor power reduction: Idle mode, Sleep mode, Power-down mode, and

Deep power-down mode. The CPU clock rate may also be controlled as needed by

changing clock sources, re-configuring PLL values, and/or altering the CPU clock divider

value. This allows a trade-off of power versus processing speed based on application

requirements. In addition, Peripheral Power Control allows shutting down the clocks to

individual on-chip peripherals, allowing fine tuning of power consumption by eliminating all

dynamic power use in any peripherals that are not required for the application. Each of the

peripherals has its own clock divider which provides even better power control.

The LPC2364/66/68 also implements a separate power domain in order to allow turning

off power to the bulk of the device while maintaining operation of the Real Time Clock and

a small SRAM, referred to as the Battery RAM.

7.24.4.1 Idle mode

In Idle mode, execution of instructions is suspended until either a Reset or interrupt

occurs. Peripheral functions continue operation during Idle mode and may generate

interrupts to cause the processor to resume execution. Idle mode eliminates dynamic

power used by the processor itself, memory systems and related controllers, and internal

buses.

7.24.4.2 Sleep mode

In Sleep mode, the oscillator is shut down and the chip receives no internal clocks. The

processor state and registers, peripheral registers, and internal SRAM values are

preserved throughout Sleep mode and the logic levels of chip pins remain static. The

output of the IRC is disabled but the IRC is not powered down for a fast wake-up later. The

32 kHz RTC oscillator is not stopped because the RTC interrupts may be used as the

wake-up source. The PLL is automatically turned off and disconnected. The CCLK and

USB clock dividers automatically get reset to zero.

The Sleep mode can be terminated and normal operation resumed by either a Reset or

certain specific interrupts that are able to function without clocks. Since all dynamic

operation of the chip is suspended, Sleep mode reduces chip power consumption to a

very low value. The Flash memory is left on in Sleep mode, allowing a very quick

wake-up.

LPC2364 Scheda tecnica(PDF) 28 Page - NXP Semiconductors

LPC2364 Scheda tecnica(HTML) 28 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Scheda tecnica Scarica

Link URL