DSP56303 datasheet(33/292 Pages) FREESCALE

33 / 292 page

Host Interface (HI08)

DSP56303 User’s Manual, Rev. 2

Freescale Semiconductor

2-9

2.7 Host Interface (HI08)

The HI08 provides a fast, parallel data-to-8-bit port that can directly connect to the host bus. The

HI08 supports a variety of standard buses and can directly connect to a number of

industry-standard microcomputers, microprocessors, DSPs, and DMA hardware.

2.7.1 Host Port Usage Considerations

Careful synchronization is required when the system reads multiple-bit registers that are written

by another asynchronous system. This is a common problem when two asynchronous systems are

connected (as they are in the Host port). The considerations for proper operation are discussed in

Table 2-10.

2.7.2 Host Port Configuration

HI08 signal functions vary according to the programmed configuration of the interface as

determined by the 16 bits in the HI08 Port Control Register (HPCR). Refer to the Chapter 6,

Host Interface (HI08), for detailed descriptions of HI08 configuration registers.

MODD/IRQD

Input

Mode Select D/External Interrupt Request D

Selects the initial chip operating mode during hardware reset and becomes

a level-sensitive or negative-edge-triggered, maskable interrupt request

input during normal instruction processing. MODA, MODB, MODC, and

MODD select one of sixteen initial chip operating modes, latched into OMR

when the RESET signal is deasserted.

Internally synchronized to CLKOUT. If IRQD is asserted synchronous to

CLKOUT, multiple processors can be re-synchronized using the WAIT

instruction and asserting IRQD to exit the Wait state.

MODD/IRQD can tolerate 5 V.

Table 2-10. Host Port Usage Considerations

Action

Description

Asynchronous read of receive

byte registers

To assure that the data in the receive byte registers is valid when you are reading the r

Receive register High (RXH), Receive register Middle (RXM), or Receive register Low (RXL),

use interrupts or poll the Receive Register Data Full (RXDF) flag that indicates data is

available.

Asynchronous write to

transmit byte registers

To ensure that the transmit byte registers transfer valid data to the Host Receive (HRX)

Transmit register Low (TXL) registers unless the Transmit register Data Empty (TXDE) bit is

set indicating that the transmit byte registers are empty.

Asynchronous write to host

vector

To ensure that the DSP interrupt control logic receives a stable vector, change the Host

Vector (HV) register only when the Host Command bit (HC) is clear.

Table 2-9. Interrupt and Mode Control (Continued)

Signal Name

Type

State During

Reset

Signal Description

DSP56303 Scheda tecnica(PDF) 33 Page - Freescale Semiconductor, Inc

DSP56303 Scheda tecnica(HTML) 33 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL