TMP86FS49AIUG datasheet(18/296 Pages) TOSHIBA

18 / 296 page

Page 2

1.1 Features

TMP86FS49AIUG

8. 8-bit timer counter : 4 ch

- Timer, Event counter, Programmable divider output (PDO),

Pulse width modulation (PWM) output,

Programmable pulse generation (PPG) modes

9. 8-bit UART : 2 ch

10. High-Speed SIO: 2ch

11. Serial Bus Interface(I2C Bus): 1ch

12. 10-bit successive approximation type AD converter

- Analog input: 16 ch

13. Key-on wakeup : 4 ch

14. Clock operation

Single clock mode

Dual clock mode

15. Low power consumption operation

STOP mode: Oscillation stops. (Battery/Capacitor back-up.)

SLOW1 mode: Low power consumption operation using low-frequency clock.(High-frequency clock

stop.)

SLOW2 mode: Low power consumption operation using low-frequency clock.(High-frequency clock

oscillate.)

IDLE0 mode: CPU stops, and only the Time-Based-Timer(TBT) on peripherals operate using high fre-

quency clock. Release by falling edge of the source clock which is set by TBTCR<TBTCK>.

IDLE1 mode: CPU stops and peripherals operate using high frequency clock. Release by interru-

puts(CPU restarts).

IDLE2 mode: CPU stops and peripherals operate using high and low frequency clock. Release by inter-

ruputs. (CPU restarts).

SLEEP0 mode: CPU stops, and only the Time-Based-Timer(TBT) on peripherals operate using low fre-

quency clock.Release by falling edge of the source clock which is set by TBTCR<TBTCK>.

SLEEP1 mode: CPU stops, and peripherals operate using low frequency clock. Release by interru-

put.(CPU restarts).

SLEEP2 mode: CPU stops and peripherals operate using high and low frequency clock.

Release by

interruput.

16. Wide operation voltage:

4.5 V to 5.5 V at 16MHz /32.768 kHz

3.0 V to 5.5 V at 8 MHz /32.768 kHz

TMP86FS49AIUG Scheda tecnica(PDF) 18 Page - Toshiba Semiconductor