ST10F271E datasheet(46/180 Pages) STMICROELECTRONICS

Il numero della parte	ST10F271E

Spiegazioni elettronici	16-bit MCU with 128 Kbyte Flash memory and 8/12 Kbyte RAM

PDF	180 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

46 / 180 page

Bootstrap loader

ST10F271B/ST10F271E

46/180

6.3

Alternate and selective boot mode (ABM and SBM)

6.3.1

Activation of the ABM and SBM

Alternate boot is activated with the combination ‘01’ on Port0L[5..4] at the rising edge of

RSTIN.

6.3.2

User mode signature integrity check

The behavior of the Selective Boot Mode is based on the computing of a signature between

the content of 2 memory locations and a comparison with a reference signature. This

requires that users who use Selective Boot have reserved and programmed the Flash

memory locations.

6.3.3

Selective boot mode

When the user signature is not correct, instead of executing the Standard Bootstrap Loader

(triggered by P0L.4 low at reset), additional check is made.

Depending on the value at the User key location, following behavior will occur:

●

A jump is performed to the Standard Bootstrap Loader

●

Only UART is enabled for bootstraping

●

Only CAN1 is enabled for bootstraping

●

The device enters an infinite loop.

ST10F271E Scheda tecnica(PDF) 46 Page - STMicroelectronics