LP3921 datasheet(20/44 Pages) TI2

20 / 44 page

LP3921

SNVS580A – AUGUST 2008 – REVISED MAY 2013

www.ti.com

The charge mode may be programmed to USB mode when the charger input is applied and the battery voltage is

above 3.0V. This provides two programmable current levels of 100 mA and 450 mA for a USB sourced supply

input at CHG_IN. Table 9.

EOC

EOC is disabled by default and should be enabled when the system processor is awake and the system detects

that a battery is present.

PROGRAMMING INFORMATION

Table 10. Register Address 8h'10: CHGCNTL1

BIT

NAME

FUNCTION

En_EOC

Enables the End Of Charge current level threshold detection.

When set to '0' the EOC is disabled.

The End Of Charge current threshold default setting is at 0.1C. This EOC value is set relative to C the set full

rate constant current. This threshold can be set to 0.1C, 0.15C, 0.2C or 0.25C by changing the contents of the

PROG_EOC[1:0] register bits.

Table 11. Register Address 8h'12: CHGCNTL3

BIT

NAME

FUNCTION

Prog_EOC[0]

Set the End Of Charge Current.

See Table 7.

Prog_EOC[1]

TERMINATION AND RESTART

The termination and restart voltage levels are determined by the data in the VTERM[1:0] and PROG_VSTRT[1:0]

bits in the control register. The restart voltage is programmed relative to the selected termination voltage.

The Termination voltages available are 4.1V, 4.2V (default), 4.3V, and 4.4V.

The Restart voltages are determined relative to the termination voltage level and may be set to 50 mV, 100 mV,

150 mV (default), and 200 mV below the set termination voltage level.

Table 12. Register Address 8h'12: CHGCNTL3

BIT

NAME

FUNCTION

VTERM[0]

Set the charging termination voltage.

See Table 6.

VTERM[1]

VRSTR[0]

Set the charging restart voltage. See Table 8.

VRSTR[1]

Submit Documentation Feedback

Product Folder Links: LP3921

LP3921 Scheda tecnica(PDF) 20 Page - Texas Instruments

LP3921 Scheda tecnica(HTML) 20 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Scheda tecnica Scarica

Link URL