7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CHARGING ELECTRONIC PRODUCTS

The jumpstarter has two USB-A ports (1

x QC3.0 quick charge port & 1 x 5V/2.4A

standard port) and one USB-C port.

1. Connect one end of a charging cable

(USB-C to USB-C or USB-A to USB-C)

to the corresponding output port of

the jumpstarter.

2. Connect the other end of the cable to your device(s).

3. If using a USB-C to USB-C cable, the jumpstarter will automatically start charging

your device; if using a USB-A to USB-C cable (not supplied), press and hold the

POWER button for 2 seconds to turn the jumpstarter on, then the jumpstarter will

start to charge your device(s).

RUNNING/CHARGING VIA DC PORT

1. Verify the jumpstarter is fully charged. Recharge if

needed.

2. Make sure the appliance has a maximum voltage of 15V

and is turned off.

3. Connect the appliance into the DC outlet 5521 socket

(5.5 x 2.1mm).

4. Turn on the appliance.

5. When finished, turn off and unplug the appliance.

6. Recharge the jump starter.

• A mobile phone may typically take one hour to

recharge.

• The jumpstarter will power off automatically when no load is found.

JUMP STARTING A VEHICLE

WARNING: IT IS POSSIBLE THAT SOME ELECTRONIC EQUIPMENT

COULD BE DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH

THE CAR MANUFACTURER’S HANDBOOK TO DETERMINE WHAT

PRECAUTIONS IF ANY SHOULD BE TAKEN.

WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND

THE SAFETY INSTRUCTIONS ON PAGES 3-4 MAY RESULT IN

PERSONAL INJURY, DAMAGE TO THE VEHICLE OR BATTERY.