EVAL-10MSOPEBZ User Guide

UG-1037

Rev. 0 | Page 3 of 6

EVALUATION BOARD HARDWARE

POWER SUPPLY

Connector J5 supplies the VDD and GND supplies to the

EVAL-10MSOPEBZ evaluation board. These supplies can be

selected for each pin of the device by setting the link headers

to either VDD or GND. When a VSS supply is needed, apply

the voltage directly to the VSS pin of the device by removing the

corresponding link completely and applying the voltage directly

to the middle pin of the link header.

LINK HEADERS

The link headers supply the DUT with either VDD or GND.

The headers are designated as K1 to K10 with the number

corresponding to the pin number of the device. Table 1 summarizes

these link headers, and how these headers function on the EVAL-

10MSOPEBZ evaluation board.

Table 1. Link Header Descriptions

Label

Position

Description

K1to K10

High

VDD

Low

GND

SMB CONNECTORS

There are four SMB connectors on evaluation board, J1 to J4.

When an SMB cable is connected to one of these connectors,

the input signal becomes available on the corresponding P1 to

P4 port. Apply this signal to the relevant pin of the device by

forming a connection from P1 to P4 to a gold pin connector

found on the relevant trace.

INPUT SIGNAL TRACES

Each trace includes three sets of gold pin connectors, two sets that

can place a load on the signal path to ground and another set that

is in series with the signal path. The three sets of gold pin

connectors can create a simple resistor capacitor (RC) filter.