PM6675STR datasheet(33/53 Pages) STMICROELECTRONICS

Il numero della parte	PM6675STR

Spiegazioni elettronici	High efficiency step-down controller with embedded 2 A LDO regulator

PDF	53 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

33 / 53 page

PM6675S

Device description

33/53

7.1.7

Switching section power good signal

The SPG pin is an open drain output used to monitor output voltage through VSNS (in fixed

output voltage mode) or VSEL (in adjustable output voltage mode) pins and is enabled after

the soft-start timer has expired. The SPG signal is held low if the output voltage drops 10%

below or rises 10 % above the nominal regulated value. The SPG output can sink current up

to 4 mA.

7.1.8

Switching section output discharge

Active soft-end of the output occurs when the SWEN (SWitching ENable) is forced low.

When the switching section is turned off, an internal 25

Ω resistor discharges the output

through the VSNS pin.

Figure 43.

Switching section soft-end

Figure 42.

Soft-start at heavy load (a) and short-circuit (b) conditions, Pulse-Skip enabled

(a)

(b)

SWEN

VOUT

Resistive Discharge

PM6675STR Scheda tecnica(PDF) 33 Page - STMicroelectronics