SH7708 datasheet(298/633 Pages) RENESAS

298 / 633 page

280

10.3.7

Burst ROM Interface

Setting bits A0BST (1,0), A5BST (1,0), and A6BST (1,0) in BCR1 to a non-zero value allows

burst ROM to be connected to areas 0, 5, and 6. The burst ROM interface provides high-speed

access to ROM that has a nibble access function. The timing for nibble access to burst ROM is

shown in figure 10.39. Two wait cycles are set. Basically, access is performed in the same way as

for normal space, but when the first cycle ends, the

CS0 signal is not negated, and only the address

is changed before the next access is executed. When 8-bit ROM is connected, the number of

consecutive accesses can be set as 4, 8, or 16 by bits A0BST (1,0), A5BST (1,0), or A6BST (1,0).

When 16-bit ROM is connected, 4 or 8 can be set in the same way. When 32-bit ROM is

connected, only 4 can be set.

WAIT pin sampling is performed in the first access if one or more wait states are set, and is

always performed in the second and subsequent accesses.

WAIT is a synchronous signal.

The second and subsequent access cycles also comprise two cycles when a burst ROM setting is

made and the wait specification is 0. The timing in this case is shown in figure 10.40.

SH7708 Scheda tecnica(PDF) 298 Page - Renesas Technology Corp