MPC8535ECVTATH datasheet(54/126 Pages) FREESCALE

54 / 126 page

MPC8535E PowerQUICC™ III Integrated Processor Hardware Specifications, Rev. 2

Ethernet: Enhanced Three-Speed Ethernet (eTSEC), MII Management

Freescale Semiconductor

When operating in SGMII mode, the eTSEC EC_GTX_CLK125 clock is not required for this port. Instead, SerDes reference

clock is required on SD2_REF_CLK and SD2_REF_CLK pins.

2.9.3.1

DC Requirements for SGMII SD2_REF_CLK and SD2_REF_CLK

The characteristics and DC requirements of the separate SerDes reference clock are described in Section 2.20, “High-Speed

Serial Interfaces.”

2.9.3.2

AC Requirements for SGMII SD2_REF_CLK and SD2_REF_CLK

Table 38 lists the SGMII SerDes reference clock AC requirements. Please note that SD2_REF_CLK and SD2_REF_CLK are

not intended to be used with, and should not be clocked by, a spread spectrum clock source.

Table 38. SD2_REF_CLK and SD2_REF_CLK AC Requirements

Symbol

Parameter Description

Min

Typical

Max

Units Notes

tREF

REFCLK cycle time

—

10 (8)

—

tREFCJ REFCLK cycle-to-cycle jitter. Difference in the period of any two adjacent

REFCLK cycles

—

100

—

tREFPJ Phase jitter. Deviation in edge location with respect to mean edge location

–50

—

2,3

Notes:

1. 8 ns applies only when 125 MHz SerDes2 reference clock frequency is selected via cfg_srds_sgmii_refclk during POR.

2. In a frequency band from 150 kHz to 15 MHz, at BER of 10E-12.

3. Total peak-to-peak deterministic jitter “Dj” should be less than or equal to 50 ps.

MPC8535ECVTATH Scheda tecnica(PDF) 54 Page - Freescale Semiconductor, Inc