ADP1752ACPZ-2.5-R7 datasheet(18/20 Pages) AD

Il numero della parte	ADP1752ACPZ-2.5-R7

Spiegazioni elettronici	0.8 A, Low VIN, Low Dropout Linear Regulator

PDF	20 Pages

Scroll/Zoom	100%

Produttore elettronici	AD [Analog Devices]

Homepage	http://www.analog.com

Logo

18 / 20 page

ADP1752/ADP1753

Data Sheet

Rev. E | Page 18 of 20

PCB LAYOUT CONSIDERATIONS

Heat dissipation from the package can be improved by increas-

ing the amount of copper attached to the pins of the ADP1752/

ADP1753. However, as shown in Table 6, a point of diminishing

returns is eventually reached, beyond which an increase in the

copper size does not yield significant heat dissipation benefits.

Here are a few general tips when designing PCBs:

•

Place the input capacitor as close as possible to the VIN

and GND pins.

•

Place the output capacitor as close as possible to the VOUT

and GND pins.

•

Place the soft start capacitor as close as possible to the SS pin.

•

Connect the load as close as possible to the VOUT and

SENSE pins (ADP1754) or to the VOUT and ADJ pins

(ADP1755).

Use of 0603 or 0805 size capacitors and resistors achieves the

smallest possible footprint solution on boards where area is

limited.

Figure 46. Evaluation Board

Figure 47. Typical Board Layout—Top Side

Figure 48. Typical Board Layout—Bottom Side

ADP1752ACPZ-2.5-R7 Scheda tecnica(PDF) 18 Page - Analog Devices