XC2230L datasheet(65/112 Pages) INFINEON

65 / 112 page

XC2230L, XC2234L

XC2000 Family / Econo Line

Electrical Parameters

Data Sheet

V1.3, 2015-02

4.3

DC Parameters

These parameters are static or average values that may be exceeded during switching

transitions (e.g. output current).

The XC223[04]L can operate within a wide supply voltage range from 3.0 V to 5.5 V.

However, during operation this supply voltage must remain within 10 percent of the

selected nominal supply voltage. It cannot vary across the full operating voltage range.

Because of the supply voltage restriction and because electrical behavior depends on

the supply voltage, the parameters are specified separately for the upper and the lower

voltage range.

During operation, the supply voltages may only change with a maximum speed of

dV/dt < 1 V/ms.

Leakage current is strongly dependent on the operating temperature and the voltage

level at the respective pin. The maximum values in the following tables apply under worst

case conditions, i.e. maximum temperature and an input level equal to the supply

voltage.

The value for the leakage current in an application can be determined by using the

respective leakage derating formula (see tables) with values from that application.

The pads of the XC223[04]L are designed to operate in various driver modes. The DC

parameter specifications refer to the pad current limits specified in Section 4.7.4.

XC2230L Scheda tecnica(PDF) 65 Page - Infineon Technologies AG