B176

BID Tool

BPrecautions

Type

Part Number

Objective Connector

Remarks

DF3-DF4 Table Insulation

SA701/DF3

DF3-*S-2R**

Desk top machine

Displacement Machine

903-4507-7

DF4-*P/PA-2R**

1. Recommended

Flow: 250ç for 3 seconds

Manual soldering: 290ç for 2 seconds

s If the cable neighboring the connector is bent and unstraightened, secure a large bending radius because the

Jacket will be broken by the solder heat and the contact wire will be exposed.The Jacket in this part will be tore.

s After the soldering process. If a stress is applied to the cable in the state where the connector and the

cable has heat inside, the Jacket hold area will be loosen. Therefore, carry out the post-soldering

operation after the connector has returned to the room temperature..

2. Cleaning Condition

Refer to Nylon Connector Use Hand book.

Don't use a solvent such ass trichloroethylene which invades the cable Jacket. In addition, avoid heat

cleaning by a solvent.

3. Connection Condition

Refer to the Nylon Connector Use Hand book.