NT5CB128M8GP-EKB datasheet(27/160 Pages) NANYA

Il numero della parte	NT5CB128M8GP-EKB

Spiegazioni elettronici	Commercial, Industrial and AutomotiveDDR3(L) 1 Gb SDRAM

PDF	160 Pages

Scroll/Zoom	100%

Produttore elettronici	NANYA [Nanya Technology Corporation.]

Homepage	http://www.nanya.com

Logo

27 / 160 page

Version 2.2

Nanya Technology Cooperation ©

04/2019

NTC Proprietary

Level: Property

DDR3(L) 1Gb SDRAM

NT5CB(C)128M8GN / NT5CB(C)64M16GP

Multi-Purpose Register (MPR)

The Multi Purpose Register (MPR) function is used to Read out a predefined system timing calibration bit sequence.

Fig. 1: MPR Block Diagram

To enable the MPR, a MODE Register Set (MRS) command must be issued to MR3 Register with bit A2 = 1, prior to issuing

the MRS command, all banks must be in the idle state (all banks precharged and tRP met). Once the MPR is enabled, any

subsequent RD or RDA commands will be redirected to the Multi Purpose Register. The resulting operation, when a RD or

RDA command is issued, is defined by MR3 bits A[1:0] when the MPR is enabled as shown. When the MPR is enabled,

only RD or RDA commands are allowed until a subsequent MRS command is issued with the MPR disabled (MR3 bit A2 =

0). Note that in MPR mode RDA has the same functionality as a READ command which means the auto precharge part of

RDA is ignored. Power-Down mode, Self-Refresh and any other non-RD/RDA command is not allowed during MPR enable

mode. The RESET function is supported during MPR enable mode.

NT5CB128M8GP-EKB Scheda tecnica(PDF) 27 Page - Nanya Technology Corporation.