TMS320F28375DPZP datasheet(82/226 Pages) TI

82 / 226 page

Wake-up

Signal

OSCCLK

XCLKOUT

Flushing Pipeline

(A)

Device

Status

STANDBY

Normal Execution

STANDBY

(G)

(B)

(C)

(D)(E)

(F)

d(IDLE-XCOS)

w(WAKE-INT)

d(WAKE-STBY)

A. IDLE instruction is executed to put the device into STANDBY mode.

B. The LPM block responds to the STANDBY signal, SYSCLK is held for a maximum 16 INTOSC1 clock cycles before being turned off.

This delay enables the CPU pipeline and any other pending operations to flush properly.

C. Clock to the peripherals are turned off. However, the PLL and watchdog are not shut down. The device is now in STANDBY mode. After

the IDLE instruction is executed, a delay of five OSCCLK cycles (minimum) is needed before the wake-up signal could be asserted.

D. The external wake-up signal is driven active.

E. The wake-up signal fed to a GPIO pin to wake up the device must meet the minimum pulse width requirement. Furthermore, this signal

must be free of glitches. If a noisy signal is fed to a GPIO pin, the wakeup behavior of the device will not be deterministic and the device

may not exit low-power mode for subsequent wakeup pulses.

F. After a latency period, the STANDBY mode is exited.

G. Normal execution resumes. The device will respond to the interrupt (if enabled).

Figure 8-18. STANDBY Entry and Exit Timing Diagram

TMS320F28379D, TMS320F28379D-Q1, TMS320F28378D, TMS320F28377D

TMS320F28377D-Q1, TMS320F28376D, TMS320F28375D, TMS320F28374D

SPRS880O – DECEMBER 2013 – REVISED FEBRUARY 2021

www.ti.com

Submit Document Feedback

Product Folder Links: TMS320F28379D TMS320F28379D-Q1 TMS320F28378D TMS320F28377D

TMS320F28377D-Q1 TMS320F28376D TMS320F28375D TMS320F28374D

TMS320F28375DPZP Scheda tecnica(PDF) 82 Page - Texas Instruments